Check engine light is on
SOURCE: need to find specks on cylingder head for 1996 toyota tercel
The cylinder head bolt torque is a 2 step process.
First: Torque all of the bolts to 45 Nm (450 Kgf-cm or 33 ft lbs.)
Replace any head bolt that will not torque to the above specs.
Second: after all ten bolts are torqued to the above specs, the head bolts are then "Torqued to Distance"...
Starting at the center bolts, retorque all ten bolts an additional 90 degrees.
Hope this helps, the graciousness of a FixYa rating would be greatly appreciated.
SOURCE: How do I reset the check engine light on a 1996 Toyota 4runner 4x
Remove the positive battery cable, step on brake for 10 seconds, then reconnect cable. This clears your ECM of the fault code, but will not eliminate the fault (which, will reset and re-light the "check engine" bulb within 50 miles if it is really a defective component).
SOURCE: torque specs for toyota tercel
Hello vienotkelly: The correct Main bolt torque is 42 foot pounds. The connecting rods torque to 29 foot pounds. The torque sequence for the head bolts and the correct way to tighten the bolts are attached to this reply. Thak You for using FixYa. Roger
SOURCE: Oil type for '94 Tercel
Hello Seth.
If the temperature you are running until your next oil change is due will be below 50F average they recommend 5w30.
Otherwise 10w 30 is the choice.
KL
Make sure electrical connection good and test for voltage and ground. If good . Replace EGR
52 views
Usually answered in minutes!
×