Need to replace the driver side window motor
Remove mirror mount cover assembly.
Remove inside door handle cup (22634).
Remove door lock control bezel.
Remove window control bezel.
Remove interior lamp lens.
Remove screw from interior lamp assembly body.
Remove screw from window control bezel opening.
Disconnect mirror, lock switches and memory seat on driver side from bezels and wire harness.
Disconnect window switches from window bezel and wire harness.
Lift front door trim panel (23942) vertically, out of weatherstrip and over lock rod.
Disconnect interior lamp (13776) from wire harness.
Remove front and rear door trim retention hooks into door inner panel.
To install, reverse Removal procedure, paying special attention when inserting inner door trim into weatherstrip. Rock inner door trim into weatherstrip and push downward until lower trim belt character ditch lines up with score mark on inner door panel.
SOURCE: lincoln mark viii
You will first need to remove the plastic piece behind the inner door handle that you use to pull the door shut with and there should be a 10mm bolt inside there behind the insulation. The plastic cover behind the inner door lever handle will need to come out. It's only in with clips. Remove the reflective lens on the end of the panel and you will see a phillips head screw inside. It's a long screw so be ready for many turns to get it out. Next, your power window controls will need to come out and they are only snapped into place but be careful with them because plastic prongs can be broken off if not pried out in the right direction. The same goes for the door lock switch. Unplug both once out. You will also see a triangle plastic piece (can break easily) towards the front top side of the panel. Make sure it clears it's way out when removing the panel. The rest of the panel is held up with downward facing plastic clips. Sounds hard but really it's all pretty simple. Study the back of the panel before putting it back on and take your time.
SOURCE: How do i remove driver door panel on a 1999
yes it can you wedge it up with a piece of wood after removing the door panel and disconnecting the drive mechanism.
WARNING: WHEN SERVICING STARTER MOTOR (11002) OR PERFORMING ANY MAINTENANCE IN THE AREA OF THE STARTER MOTOR, NOTE THE HEAVY GAUGE INPUT LEAD CONNECTED TO THE STARTER SOLENOID (11390) IS HOT AT ALL TIMES. MAKE SURE THE PROTECTIVE CAP IS INSTALLED OVER THE TERMINAL AND IS REPLACED AFTER SERVICE. CAUTION: When disconnecting hardshell connector at S-terminal, grasp the plastic shell and pull off. Do not pull on wire. Be careful to pull straight off to prevent damage to the connector and S-terminal. If any part of the connection is damaged, replace the damaged components. 1,004 views
Usually answered in minutes!
×