Reset x type 2.2d service indicator

RESET service indicator ALL VEHICLES

Mercedes Service Indicator Reset C300 - YouTube

? 3:53
https://www.youtube.com/watch?v=2bLjAhIamyc
Jun 8, 2013 - Uploaded by Liqidarts
Easily reset your service A or service B indicator on you Mercedes Benz. Very useful if you do your own ...

Reset service indicator C300 C350 C63 Mercedes 2008 ...

? 1:47
https://www.youtube.com/watch?v=PdFLoZ1kNYI
May 23, 2012 - Uploaded by Liqidarts
How to reset service A or B indicators on your Mercedes C class, useful when you change your own oil.

How to reset maintenance service reminder without going to dealer ...

mbworld.org/.../473535-how-reset-maintenance-service-reminder-witho...

Some service indicators can be reset and some owners handbooks give instructions for doing so. Some indicators can only be reset using dedicated diagnostic equipment.
VW use both types depending on whether the vehicle is programmed for normal service intervals or longlife intervals. I suggest you seek advice from your local dealer.

hold the reset button in, on the rh of facia.switch on ignition, relesase button and press the button on the end of the indicator switch then press reset button and hold both it will say resetting service mode keep both pressed until service mode reset is showing you have to be quick with the sequence if that wont work it may have to be done by dealer

OTE: If the service interval indicator flashes it may be caused by one of the service interval indicator parameters not being programmed. This can only be carried out using suitable diagnostic equipment. Always check for any stored trouble codes as this may affect the resetting of the service interval indicator.
Ensure all doors are closed. Turn ignition key to position I. Press and hold reset button [A] 104667 07, 116126 07 Immediately turn ignition key to position II (within 2 seconds). Keep button [A] depressed until service message has been reset. A yellow warning light [B] will illuminate when it is time to release button [A]. Release reset button [A] within 4 seconds. There will be an audible signal when reset is complete. If reset button is not released within 4 seconds, the service interval indicator will not be reset.
RESET BUTTON IS TRIP BUTTON

VW group have TWO service regimes,annually/10k or extended ( when the service indicator shows when you need to service it).this is set when the dealer supplies the car NEW.it cannot be reset after.VW group products fit 5/30 fully synthetic when new and the type of oil for services is determined by the service type,I.E. annual/10k services, use 10/40 semi synthetic and for extended/20k services use 10/40 fully synthetic.check the oil every 500 miles as ALL VW will use oil.if you bought the car used, then, rather than use the service indicator, do an oil change EVERY year and use semi 10/40.if a dealer services the car the service indicator should be reset EVERY time.

NOTE: If the service interval indicator flashes it may be caused by one of the service interval indicator parameters not being programmed. This can only be done with suitable diagnostic equipment. Always check for any stored trouble codes as this may affect the resetting of the service interval indicator.
Turn ignition key to position I. Press and hold reset button [A] 20573 for trip meter. Turn ignition key to position II. Keep button [A] depressed until service interval indicator flashes (approximately 10 seconds). Release reset button [A] within 5 seconds. There will be an audible signal when reset complete. If reset button is not released within 5 seconds, the service interval indicator will not be reset but will stop flashing.

Both, it has an On Board Diagnostic computer, or OBD-II. For giving problem codes. But as far as in tune up wise, only has one for the oil.

The way to reset any E46 BMW (3 series 1999-2005) is as follows:

Turn the car off and then hold in the odometer reset button on the left side of the dash. Turn the key to on but not start. Hold for a few seconds and the service reminder will show in the instrument panel. Release then double push the button and the service reminder will reset. If you just keep single pushing at that point, you will be surprised about all the information you can learn.

if i understand you correctly just disconnect the power lead to the battery for a few minutes and then reconnect it