Blower motor work in high speed
SOURCE: Blower motor has only low speed
You may need to get the correct resistor, as they are designed to only allow so much amperage to go through them. If it is getting very hot it is runnig to many amps through it. It will eventually blow and you will need to replace it anyway.
SOURCE: In 2002 Toyota Echo, I need to replace blower
blower switch is your fan knob on dash. resistors are located under pass side dash next to blower motor. on alot of cars the blower will work on high speed and not the lower ones- this is a tell tale way to tell the resistor is no good. if this happens again after replacing resistor- ive seen the blower motor shorting out causing the resistor to go bad- then you would have to replace both.(this usually dosnt happen, most often the resistor alone fixes the problem..
SOURCE: heater blower motor not working on 2003 echo
no power at the resistor of the blower fan 2003 toyota ecko
SOURCE: how do you replace the blower motor resistor in a
The resistor pack is almost always close to the blower. It needs air moving across it to keep it cool. It is usually installed into the duct with two small screws. It has a connector with about 5 -6 wires, and is about 3/4 inch wide, and about 3-4 inches long. Some can be a little difficult to get out due to clearance, and their shape.
Also, it could be the fan speed switch that's giving you problems.
558 views
Usually answered in minutes!
×