When ignition is off key won't release security light flashing. What could be the cause?
SOURCE: Key stuck in ignition 2007 Ford Fusion
i read other forums and found out if you remove the ring around the shifter button it releases the key. sometimes this gets stuck and the car thinks it is still in gear so it will not allow the key to release. this worked when it happen to me!
SOURCE: Spare Key will not start the car.
no you don't have to have it done at dealership. i bought mine on ebay got it cut at walmart and it works. you need the two originals, turn the ignition to on and then off 4 times (i think it was) with the first two then put your spare key in and do the same. and it will work.
http://www.mazda3forums.com/index.php?topic=5340.0
The timing is critical to this procedure, please read through the entire procedure before attempting.
Procedure:
1. Insert one of the pre-programmed transponder keys and turn the ignition to "on", leave on for at least one second (I wait until the red key symbol in the instrument cluster extiinguishes), remove the key from the ignition.
2. Within 5 seconds insert the second pre-programmed key and urn the ignition to "on" for at least one second but no more than 5 seconds (use the key symbol for this as well) then remove the second key.
3. within 10 seconds insert the new key in the ignition and turn the ignition to "on", if you are successful the red key symbol will illuminate then extinguish after about a second.
If you are not successful the red key symbol will flash repeatedly to indicate that you have inserted an invalid key. Remove the key, wait a minute and try it again, it took me a few times to get it perfect and I had done it before.
SOURCE: Key won't come out of ignition on 2007 ford
do you have the steering wheel turned or any tension at steering wheel? wiggle your wheel while turning the key and it
SOURCE: 2007 ford fusion sunroof wont open what would be
CHECK FUSE IF OKAY.CHECK TO SEE IF POWER GOING TO SUNROOF MOTOR SWITCH IF YES SUNROOF MOTOR COULD BE FAULTY OR IT NEED ADJUSTMENT.SWITCH COULD BE BAD.IF SWITCH IS GETTING NO POWER FUSE IS GOOD THERE IS A BROKEN WIRE FROM FUSE TO SWITCH.
SOURCE: when i turn my car off i can't remove the key from
Either the ignition cyllinder is locked up, or your gear shifter isn't set. Play with the shifter button on your shifter and try to remove the button. Should be a plastic cap. That cap gets jammed sometimes, and this prevents you from removing your key.
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by "do-it-yourselfers". Do not assume that a condition described affects your car or truck. Contact a Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company's on-line technical resources.
Copyright © 2007 Ford Motor Company
157 views
Usually answered in minutes!
×