SOURCE: nissan patrol
1 st stage tension is 59 nm
2 nd stage tension is 108nm
hope this helps you out
SOURCE: nissan navara 2006 blown hole no1 piston 16000kms
do you have a hole in the piston or gasket? If in the piston it is most likely from coolant or water. If water, could be a cracked head, or being sucked in through the intake and building up in the 6th cyl. I have a lexus that had a hole in the side of the motor and noon could figure out why. I pulled the head and found water... Put new block in and egr codes came up. Pulled EGR and found it was sucking in water, due to an exhaust leak that was allowing condensation to build and would not blow out once in the egr tube. If you face the same problem (hole in block) I am going to say too much compression. Could be from head gasket not being torqued properly and leaking cooland, cracked head, or wrong spark plugs-and worst case scenario which I have yet to witness, bad spark plug gap. Not likely on your car, i would think.
SOURCE: EGR valve
pop the hood
take the air intake box off
look down under the throttle body
its sitting right under
SOURCE: The battery , h/brake, sub
Mine same mod did the same yesterday , have put a volteage meter accross the alt abd it appeard to be not charging so i guess it has had it , was replaceed 18mts ago, bugger
SOURCE: Need to replace head gasket
I frequently use and highly recommend registering for free at www.autozone.com Your registration gives you access to a variety of repair and shop manuals, most giving you detailed repair instructions diagrams and specs.
526 views
Usually answered in minutes!
×