Light appeared on dashboard stating maintenance required
SOURCE: Honda elements maintenance required
Press the odometer button when starting the engine. The light will go off.
SOURCE: Maintenance Required light on after dead battery
No its easy . here are the steps turn ignition to acc/ first turn hold reset button located next to odometer rest button. Hold this button for 30 seconds. then turn ignition to next turn/click where lights come on on the dash ex brake air bag etc. hold for another 30 seconds. The maintenance light should flash and go out start vehicle and your maintenance is done. Good luck ad thanks for using FIX YA
SOURCE: Maintenance required light is orange
it comes on after a certain amount of miles
look it over check all belts hoses brakes fluids
and check the timing belt if all looks good put your key in the slot next to orange light and it will goto green again if you don't reset it will goto red in a few miles but it is not the check eng. light just a reminder
SOURCE: The maintenance required light in the dash just
this tells you that you need your oil change to be changed if you got the eng lite on then you have problem with the eng
Sit inside the driver's seat of the Honda Accord and close the driver's side door. Any interior lights on can prevent the maintenance required light from resetting properly on some year models.
Insert the key in the ignition.
Depress the odometer/trip button located beneath the odometer on the instrument panel. Hold the button down.
Turn the ignition key two clicks forward to the accessory power position. This is also known as the key-on/engine-off position.
Continue to hold down the odometer/trip button for up to 15 seconds until the maintenance required light goes out. On some Accord models, the maintenance required light may blink once before going out.
Release the odometer/trip button and then turn the ignition key to the off position.
Start the Honda Accord to ensure the maintenance required light is no longer illuminated on the instrument panel. If it still is, the reset procedure did not take and you'll need to repeat the procedure.
179 views
Usually answered in minutes!
×