Yes....lift the lever on the right side of the back rest and fold it
forward....lift the latches in the rear seat legs and rotate the seat forward and out of the floor mounts.
Regards,
Dennis
All seats are removable its how far are you willing to go to most ar bolted and these very tight hex heads or torx will require some work
SOURCE: rear heat or rear air conditoner not workin in my 1997 gmc safari
two different problems !
Rear heater problem: find under the hood where is hose for cooling liquid goes to front heating core!
you will see there also vacuum tubesgoing in to little valve ! disconnect the vaccum tubes ( engine off)
and spray in wd 40 in to the vlave ... valve is stuck and wont open flow to rear heater !
you do not have to replace tha thing . its very well made and because you dont turn this often in summer
it gets stuck. i had same problem. also make sure vacuum is working - Engine running turn rear heater on - vacuum sucks to open valve. and before that make sure fuse is ok .
for rear AC mine does not work either and it is leak on pipes that go from front to rear .. 10 feet of pipes and tubing $$ expensive repair ... forget it ... open the window...
jebadiah
SOURCE: How do you lay down rear seat flat?
I just bought a 93 GMC Safari Van and couldn't figure this out either. Luckily, I did have the manual. It appears that the lever under the front of the sofa moves in forwards and backwards. There is a lever on the corner of each side. Lift up on each and pull cushion forward. Also, you can push on the back of the sofa to help it go down. Hope this helps!
SOURCE: how to take off the cooling fan from 1997 gmc safari
you will need a special tool to remove #3 fan clutch.
Installation is the reverse of the removal procedure. Tighten the components to the following specifications:
the tool is sold in pep boys auto zone and many auto parts.
SOURCE: 2004 GMC safari rear electric door lock is not working
remove panel, if any, check for loose wires, clean and lubicate
SOURCE: GMC Safari power locks stoped working, I cannot
You need power to open it since it is controlled by an actuator.
204 views
Usually answered in minutes!
×