SOURCE: replacing main belt on chevy truck 4.8 engine
remove the belt to ac compressor.take your serpentine belt go around crank pulley goes around power steering pump goes around alternator and the tensioner on the far left. the water pump on the out side and the top idler pulley out side. the belt drives them from the out side. then you put your ac compressor belt back on.
SOURCE: belt diagram for a 2006 chevy monte carlo
There should be a decal on the bottom side of your hood, or somewhere in the engine compartment. If there isn't just put it on the crankshaft (bottom pulley) and go ribs to ribs, and flats to flats, and work your way around.
SOURCE: serpentine belt diagram for 2003 chevy impala
send an email to [email protected] and I will send the diagram to you
SOURCE: removal of 1976 chevy truck ignition switch
need a special tool to remove the locking plate behind steering wheel then pull turn signal switch back a little then remove screw that keeps lock cylinder in place
SOURCE: replacing serpentine belt on 2000 chevy van need belt diagram
My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.
I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.
I am assuming this "van" is a Chevy Venture?
CLICK on the following LINK. It has the Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies...
http://www.2carpros.com/car_repair_information/year/2000/make/chevrolet/model/venture/2000_chevrolet_venture_drive_belt_routing_diagram.htm
898 views
Usually answered in minutes!
×