P1570 fault code p1570 engine will not start

car runs and drives, wow not told.
that is a factory code P1.
and as all factory codes , are, p1, only truth is from Honda
and even 1 model car only.
no country told. and matters. sad to say.
the best answer is always in the honda service manual for the car.
it event tells how the P1570 test is setup and completed.
it means
Battery Module Individual Voltage Problem
BCM errors. is the car battery low?or was it? if yes reset the code and drive see if it returns.
this car needs service and Hybrids are complex and costly to repair and have unique HV safety procedures and methods that can not be ignored.

the manual covers this and is a set of long complex tests
if car battery is good. (main batter 12vdc)

OBD2 fault codes go by make the first digit is a "1", so go here and look it up for your make. If you need more help comment back
http://www.obd-codes.com/trouble_codes

code p1570 refers to ignition switch control module/ECM-attempted theft/data bus/not compatible ===causes --wiring--connections--trouble codes stored in other system--ignition switch control module---ECM
If this is a recent problem I would suggest that the ignition switch module be checked/replaced.

have you had the codes reaset ? if so then i'd think your looking to get the eng control module changed

well, you bought a car that takes a NASA engineer to keep going
so take it to the man.?
if really feeling safe working any HV car. (high voltage)
I am but are you? DIY?
then buy the FSM and read, it , then ask questions.

join the honda hybrid forum. ask there..... vast hits on same.
zero here.

Go here:

http://www.obd-codes.com/trouble_codes/volkswagen/

Not Good: The Expensive main computer brain sustained a short from either the heat of the solutions or leakage allowing fluids to enter the components. If after a drying period this still occurs; then the computer brain needs replacing.

It means that your car will not start because the immobilizer has been activated.

Dear Madam or Sir,

this is a well known problem with the immobilizer system.

See the following official tech bulletin :

Affected vehicles:
All models with Bosch RB8 instrument panel up to 2002 MY.


Problem:

Engine starts and cuts out immediately.

Trouble code stored: 17978 (P1570) - engine control module (ECM), immobilizer active.

Trouble code stored: 18058 (P1650) - CAN data bus, instrumentation - no signal.


Cause
Immobilizer fault.
System arms when ignition switched ON.

Remedy:
Access fault memory. If trouble codes present fit modified instrument panel (incorporating immobilizer control module).

Note: Immobilizer can only be programmed using diagnostic equipment.

P1557 is an overboost condition, poss. from sticky vanes or actuator in the turbo. P1570 is due to your immobilizer being tripped somtime in the recent past. As long as the car still starts and doesn't shut off a few seconds later this poses no problem