Replace the alternator
Not an easy diy write up in this fixya format
time to purchase a repair manual for the highlander
SHOP MANUAL HIGHLANDER SERVICE REPAIR TOYOTA BOOK HAYNES CHILTON WORKSHOP...
SOURCE: 1994 toyota corolla alternator belt replacement
loosen the bolt that is holding the adjuster of the alternator. loosen the belt by pulling it and the alternator would slide in. remove and replace the belt.
do the reverse on installation.
remember to tighten all bolts of the adjuster and alternator after tightening the belt.
tnx 4 using fixya,
drcool
SOURCE: Alternator belt replacement of 1989 Toyota pickup
Start with the power steering belt it takes a 12 mm socket for the bolt in the power steering . also loosen the bolt on the power steering pump pulley. remove the radiator lower fan shroud. It just clips in. pull the power steering belt around the fan and out of the engine compartment then do the a/c belt. That is the best way I know how.
SOURCE: replace bulb on automatic gear shift console
If the shift console is on floor then look for bolts holding it down. Take out bolts and then you can maneuver console so you can see where light is plugged in and get the right light to replace it. It will probably be a small light which tend to cost a bit more, but at least you'll have the light back.
SOURCE: I need details on how to replace the alternator
Loosen bolt A (pivot) and B (lock-bolt), then adjust C to loosen the belt so it can be removed.
Then, having routed the new belt as the old one was, tighten C until the belt has ~1/4-1/2" deflection with moderate thumb pressure. Then tighten down bolts A (torque to 38 ft-lbs) and B (to 15 ft-lbs).
SOURCE: replace alternator for 1994 toyota 4 cyl. pickup
I've found the bolt that the alternator pivots on to be not much fun. A small palm type ratchet has been helpful. Here's an online manual's alternator section: http://myweb.dal.ca/is353832/93fsm/charging/3generato.pdf
1,538 views
Usually answered in minutes!
×