HOW TO RESET THE LOW TIRE LIGHT

First, check the tire pressure of the spare. If all tires are properly inflated, then one of the sensors are bad and must be replaced.

There is a specific procedure for resetting the tire pressure sensor system that must be followed. You Owners Manual should have it. Switching the tires around will cause this, as will a faulty pressure sensor or signal transmitter/receiver

Its the low tire light. On the drivers side door opening you should be able to find a sticker that tells you the proper tire inflation for you vehicle. Check all four tires to make sure they are properly inflated. If that tire is low it probably indicates there is a leak. Once all four tires are inflated drive the vehicle on the freeway for about ten minutes. the light should go out. If the light comes back on and the same tire is low than there is definitely a leak.

If all the tires are properly inflated and the light comes on there may be a problem with the sensor in that wheel. A TPMS scanner will be needed to see what the sensors are displaying for pressure.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Hi, the tire pressure monitor detects any changes in the tire inflation pressure. Therefore, it must initialize and store it in its memory if the tires or wheels have been replaced, re-inflated or the tires have been rotated. You can re-initialize the system by following these steps:

1. Check and make sure that your tires are inflated to the correct pressure

2. Turn the ignition switch to the ON position. If the low tire pressure warning light comes on, push and hold the tire pressure warning reset switch (in the glove box) until the warning light turns off and then release the switch.

3. Now press and hold the tire pressure warning reset switch until the low tire pressure warning light blinks three times.

4. Initialization is *not* completed until driving at the vehicle speed of 19 mph or over for more than one hour. the tire pressure monitoring starts when initialization is completed.

If all tires are properly inflated you have 1 or more bad tire pressure monitors in your wheels. Will need to hook up to a tire pressure monitor scanner & it will tell you which one is bad. They are connected to the bottom of your valve stem in every wheel.

press and hold the tire pressure reset button for 5 sec or until u see the light flash

the TPMS light is the low tire warning light (Tire Pressure Monitoring System). Inside the drivers front door there will be a sticker that tells you what the tires should be inflated to. Check all the tires and make sure they are properly inflated. This should be done when the tires are cold.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Have you pumped air to the proper pressure and light still on? Did u check spare tire pressure too? On my car, the lights goes off once all 5 tires are properly inflated.

Have any of the tires been replaced recently? If so get the sensors checked for a dead sensor. If you have a dead sensor, blame it on your tire guy. They destroy them with unfortuante regularity.

...Just make sure that when you check the tires, use an accurate gauge. The tire pumps at service stations are not accurate, and the pen-looking things to check tire pressures are not accurate either.

Hold down the reset for a few seconds until the light goes out. If this does not work, repeat.