2009 Volvo V50 Logo

Related Topics:

A
Anonymous Posted on Jul 22, 2014

What does ECM A610- additive dosage module faulty signal mean?

Warning came up dash. Red triangle and engine service system urgent message

1 Answer

mr-fix

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Volvo Master 405 Answers
  • Posted on May 09, 2017
mr-fix
Volvo Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jan 20, 2015
Answers
405
Questions
0
Helped
342310
Points
3488

You have a problem with the DPF additive system.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Apr 06, 2009

SOURCE: 2001 volvo s60 t5 - performance reduced warning message, limp mode activated

I had exactly the same problem on my UK 2001 S60.
It was caused by the throttle control housing gaskets not being serviced properly and consequently the entire housing had to be replaced - not a cheap job -and a valuable lesson learned - use a reputable volvo specialist to service your volvo - I didn't and I learnt the hard why! only a volvo specilaist would have known about this I went to several other main street garages & none of them could even diagnose the problem let alone fix it. Although they did do numerous other things first before they gave up - ie replaced titanium spark plugs.
Before it stoppped running altogther and went into "limp home mode" there were tell-tale engine/throttle surges when the car was idle, but in gear.
It is now running "like new" & I will never get another garage to service it, as this could have been avoided - however they can also wear out after about 10years - so my bad services just made it happen sooner!
I hope this helps!

Ad

Anonymous

  • 109 Answers
  • Posted on May 12, 2009

SOURCE: message system reads "engine system maintenance required"

WHAT HAPPENED IS WHEN YOU SHUT DOWN AND RESTARTED YOU (RESET THE ENGINE MANAGEMENT COMPUTER) AND THE SERVICE LIGHT SHOULD GO OUT AFTER 10 MINUTES OF DRIVING

Anonymous

  • 60 Answers
  • Posted on Dec 02, 2009

SOURCE: Warning light on volvo v40, red outlined triangle,

It is a lambda sign. It is the same thing as a check engine light. It means the car has registered and stored a diagnostic trouble code for some system. The codes will need to be read.

Anonymous

  • 4044 Answers
  • Posted on Jun 21, 2010

SOURCE: error code on dash display

Take the vehicle to Auto Zone or O'Reilley's auto parts of any local auto parts store that offers to read stored codes for free and they will be able to tell you exactly what codes are showing and what they mean for free. In addition you will be able to by the repair parts while your there.

Anonymous

  • 2 Answers
  • Posted on Sep 15, 2010

SOURCE: what does power system service urgent message mean

Posssible charging system fault. Alternator/battery etc. If the battery is not charging and you use vehicle it will breakdown

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers

2004 infinity fx35 code c1130 and no start no blown fuses or fuse links any ideas

Possible causes Faulty Engine Control Module (ECM) Faulty ABS actuator and electric unit (control unit) Control Area Network (CAN) communication line Blown ECM fuses What does this mean? Tech notes The code means that the Anti-Lock Brake System (ABS) control unit has detected that there is a problem with the Engine Control Module (ECM). What does this mean? When is the code detected? Based on the signal from Engine Control Module (ECM), the Control Area Network (CAN)-Local Area Network (LAN) converter (CLC) judges that the engine control system is malfunctioning. Possible symptoms ABS Warning Light ON Scanner cannot access Engine Control Module (ECM) C1130 Infiniti Description ABS actuator and electric unit (control unit) and ECM exchange the engine signal with CAN communication line. Major engine components are malfunctioning.

Read more: https://www.engine-codes.com/c1130_infiniti.html
0helpful
1answer

Error Code P0351 for a 2005 Toyota Avalon

Possible causes
Faulty Ignition Coil 1
Ignition Coil 1 harness is open or shorted
Ignition Coil 1 circuit poor electrical connection
Faulty Engine Control Module (ECM)

What does this mean? When is the code detected? Each ignition circuit is continuously monitored by the Engine Control Module (ECM). The test fails when the ECM does not receive a valid pulse signal from the ignition coil. Possible symptoms Engine Light ON (or Service Engine Soon Warning Light) Lack/Loss of Power Engine may be harder to start Engine hesitation Rough engine idle P0351 TOYOTA Description: The ignition system on the vehicle uses individual ignition coils for each cylinder. The Engine Control Module (ECM) controls each ignition coil operation. The ECM sends a ON/OFF signal to energize the ignition coil to create a spark at the spark plug when a spark is required at the cylinder.
0helpful
1answer

2003 sta fe hyundai give code 121

P0121 HYUNDAI - Throttle/Pedal Position Sensor/Switch 'A' Circuit Range/Performance

Possible causes - Faulty throttle position sensor - Throttle position sensor harness is open or shorted - Throttle position sensor circuit poor electrical connection - Faulty Engine Control Module (ECM) What does this mean? When is the code detected? Malfunction is detected when an excessively low or high voltage from the sensor is sent to ECM. Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) P0121 Hyundai Description The throttle position sensor (TPS) responds to the accelerator pedal movement. This sensor is a kind of potentiometer which transforms the throttle position into output voltage, and emits the voltage signal to the Engine Control Module (ECM). In addition, the sensor detects the opening and closing speed of the throttle valve and feeds the voltage signal to the ECM. Idle position of the throttle valve is determined by the ECM receiving the signal from the throttle position sensor. This sensor controls engine operation such as fuel cut. On the other hand, the Wide open and closed throttle position switch, which is built into the throttle position sensor unit, is not used for engine control.
0helpful
1answer

What does code P 119 mean on my Cadillac 1994 Seville STS

P0119 Cadillac Engine Coolant Temperature Circuit Intermittent
Possible causes - Low engine coolant level
- Faulty Engine Coolant Temperature (ECT) sensor
- Faulty engine coolant thermostat
- Engine Coolant Temperature (ECT) sensor harness is open or shorted
- Engine Coolant Temperature (ECT) sensor electrical circuit poor connection What about the obd code? The Engine Control Module (ECM) detected an erratic signal from the engine Coolant Temperature (ECT) sensor during the system monitor test Symptoms - Engine Light ON (or Service Engine Soon Warning Light) P0119 Cadillac Description The Engine Coolant Temperature (ECT) sensor is used to detect the engine coolant temperature. The sensor modifies a voltage signal from the Engine Control Module (ECM). The modified signal returns to the ECM as the engine coolant temperature input. The sensor uses a thermistor which is sensitive to the change in temperature. The electrical resistance of the thermistor decreases as temperature increases.
P119 or P0119 ?

P119 - Shorted Fuel Injector Problem
or
0helpful
1answer

What is code p0727

Possible causes
- Faulty Crankshaft Position (CKP) Sensor
- Crankshaft Position (CKP) Sensor harness is open or shorted
- Crankshaft Position (CKP) Sensor circuit poor electrical connection
- Communication error between the Engine Control Module (ECM) and Transmission Control Module (TCM)

The P0727 Codes is triggered when the TCM receives no signal from the ECM.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P0727 Description
The Engine Control Module (ECM) monitors the engine speed through the Crankshaft Position (CKP) sensor with the engine running, and send signal to the Transmission Control Module (TCM).


0helpful
1answer

I have a PO350 code on my Hyundai xg350L. What does it mean and how do I fix it?

P0350 Hyundai - Ignition Coil Primary/Secondary Circuit pdf.gif share.png 2 0 [img alt="P0350 Hyundai Comments" src="http://7ff587e0977842abc470-bfcce390d0a24108a1dce58e5acfca1f.r31.cf1.rackcdn.com/comments.png"> ' Add Comment - Faulty Ignition Coil Primary/Secondary
- Ignition Coil Primary/Secondary harness is open or shorted
- Ignition Coil Primary/Secondary circuit poor electrical connection
- Faulty Engine Control Module (ECM)
[img src="http://7ff587e0977842abc470-bfcce390d0a24108a1dce58e5acfca1f.r31.cf1.rackcdn.com/help.jpg" alt="What does this mean?" > What does this mean?
When is the code detected?
The test fails when the Engine Control Module (ECM) does not receive a valid pulse signal from the ignition coil.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Lack/Loss of Power
- Engine may be harder to start
- Engine hesitation
- Rough engine idle
P0350 Hyundai Description
The ignition signal from the Engine Control Module (ECM) is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the proper high voltage in the coil secondary circuit.


Read more: http://engine-codes.com/p0350_hyundai.html#ixzz3JNf6yMdg
0helpful
1answer

I have code p0573 saying brake switch A is high although brake lights are working ok, can anyone help please

Possible causes
- Faulty Brake Switch
- Brake Switch harness is open or shorted
- Brake Switch circuit poor electrical connection
help.jpg What does this mean? When is the code detected?
The P0573 codes is set when the stop light switch signal is too high.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Stop light inoperative
- Cruise control system inoperative
P0573 Description
When the brake pedal is depressed, the stop light switch sends a signal to the Engine Control Module (ECM). When the ECM receives this signal, it cancels the cruise control.
0helpful
1answer

I have grand cherokee 2001 limited the code p0700 is apper the gear is started scend shift espically in morinig

possible causes
Shorted or open circuit within Transmission Control Module (TCM)
- Faulty Transmission Control Module (TCM)
symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Driveability problems
- Transmission shifting problems
p0700 description
The transaxle Control Module (TCM) monitors the malfunction of sensors and actuators relating to transaxle control. When the TCM detects a malfunction with the control, a signal is send to the Engine Control Module (ECM) to trigger the Engine Light or Service Engine Soon light. The ECM stores the P0700 code and it means the TCM detected a malfunction with the transaxle controls.

Read more: http://engine-codes.com/p0700_jeep.html#ixzz2hihK6PVo
0helpful
1answer

Volvo v70d5 2002 model air bag service urgent warning on

See if you can pull the airbag fuse to avoid accidental deployment of the airbags. It sounds expensive.
Not finding what you are looking for?

7,866 views

Ask a Question

Usually answered in minutes!

Top Volvo Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...