I need the firing order of the spark plug wiring and a wire diagram of the spark plugs

From the timing belt to the transmission the fireing orders are 1234 One and three fired the same time 2 and 4 fire the same time. Pull all the plugs for the spark plug on them and lay them across the top of the motor with plugs in them you can see which ones fire at what time. The spark plugs need to be touching a grounded part of the engine to fire. This also will help you find out if you have bad wires.

Greg Bernett 2821 Solutions February 14, 2010
You didn't post your engine size so please pick the applicable diagram:



1996-98 4.3L Engines Firing Order: 1-6-5-4-3-2Distributor Rotation: Clockwise



1996-98 5.0L, 5.7L and 7.4L Engines Firing Order: 1-8-4-3-6-5-7-2Distributor Rotation: Clockwise




4.3L Engines Firing order: 1-6-5-4-3-2 Distributor rotation: Clockwise



4.8L, 5.3L and 6.0L Engines Firing order: 1-8-7-2-6-5-4-3 Distributorless ignition system (one coil on each cylinder)



5.0L, 5.7L and 7.4L Engines Firing order: 1-8-4-3-6-5-7-2 Distributor rotation: Clockwise

Source: spark plug wiring diagram for 98 tahoe

• 1

• 
  ledsled378 2926 Solutions July 24, 2010
  

..............................

Source: Need diagram for spark plug wiring for 1997 Chevy

Testimonial: "Thank you for your prompt response. Saved my husband from some distress!"
Was this solution helpful? Yes No

• 
  Dennis Weid. 44272 Solutions September 16, 2008
  

This was all I could come with, hope it helps.

It can be faulty or dirty spark plug itselfd.Also for reference get the fuel level checked.Is the fuel tank is empty or near to empty.
Try cleaning the spark plugs and then see if that is helpin.On some cases the black carbon layer gets collected on the spark plugs and that causes the problem,so cleaning the plugs help.But if its not helping,then spark plug has to be replaced.Spark plugs get power from ignition coil to ignite sparks.If ignitioncoils are faulty then also there will no spark.--------------

To troubleshot and confirm the issue,i suggest you to go through the help links provided below,check the procedure and it will help you to confirm the issue in your case.
----------
Click the link below:------

Car cranks, has spark but will not ?

http://howtobyme.blogspot.com/2011/12/car-crankshas-spark-but-will-not-start.html

-----------

The spark plug firing order for car?

http://schematicsdiagram.blogspot.com/2011/06/spark-plug-firing-order-for-car.html

------------

How to Replace Spark Plugs?

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-spark-plugs.html

---------------

How to Perform a Basic Engine Tune Up-Spark Plug and Wire Change

http://schematicsdiagram.blogspot.com/2011/08/how-to-perform-basic-engine-tune-up_01.html

----------

Car has no spark?

http://schematicsdiagram.blogspot.com/2011/06/car-has-no-spark.html

---------

How does the spark plug wire go on the distributor cap in 1991 Mitsubishi Mighty?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wires-go-on.html

------------
No spark on 2008 Chevy Avalanche?

http://schematicsdiagram.blogspot.in/2012/04/no-spark-on-2008-chevy-avalanche.html

-----------

How does the spark plug wire go on the distributor cap in 1985 Pontiac sunbird?

http://schematicsdiagram.blogspot.com/2011/12/how-does-spark-plug-wire-go-on.html

--------------

Ford Plug Wires Not Coming out?

http://whoisbyme.blogspot.in/2012/06/ford-plug-wires-not-coming-out.html

--------

Ford explorer has no spark?

http://schematicsdiagram.blogspot.com/2011/12/ford-explorer-has-no-spark.html

----------

Chevy impala spark plug firing order diagrams?

http://technoanswers.blogspot.in/2012/02/chevy-impala-spark-plug-firing-order.html

------------

How to gap spark plug on Chevy Impala?

http://technoanswers.blogspot.in/2012/02/how-to-gap-spark-plug-on-chevy-impala.html

-----------

Spark plug Replacing for chevy impala?

http://technoanswers.blogspot.in/2012/02/spark-plug-replacing-for-chevy-impala.html

Chevy s-10 blazer 4.3l Spark Plug Firing Order?

http://howtobyme.blogspot.com/2011/12/chevy-s-10-blazer-43l-spark-plug-firing.html

----------------

1982 dodge rampage Spark plugs Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/1982-dodge-rampage-spark-plug-firing.html

----------------

2006 Suzuki Forenza Spark plug Firing Order Diagram?

http://schematicsdiagram.blogspot.com/2011/12/2006-suzuki-forenza-spark-plug-firing.html

------------

1983 Ford Ranger Spark plug firing order?

http://schematicsdiagram.blogspot.com/2011/12/1983-ford-ranger-spark-plug-firing.html

--------

Firing Order for 1991 Lexus ES 250?

http://schematicsdiagram.blogspot.com/2011/12/firing-order-for-1991-lexus-es-250.html

----------------

Firing order for 1992 Chevrolet 5.0 engine?

http://schematicsdiagram.blogspot.com/2011/12/firing-order-for-1992-chevrolet-50.html

-----------

How to identify number one spark plug on the distributor cap?

http://schematicsdiagram.blogspot.com/2011/12/how-to-identify-number-one-spark-plug.html

-----------

How to remove rear spark plugs on 1991 Buick Regal?

http://howtobyme.blogspot.in/2012/02/how-to-remove-rear-spark-plugs-on-1991.html

---------------

These details will help.

Thanks.

Hope this helps. The ignition coil:

• changes low-voltage pulses from the PCM to high-voltage pulses.
• fires 2 spark plugs simultaneously.
• has 3 transformers.
  • One transformer fires the spark plugs for cylinders 1 and 5
  • One transformer fires the spark plugs for cylinders 2 and 6
  • One transformer fires the spark plugs for cylinders 3 and 4

Spark plug wires:

• carry high-voltage pulses from the ignition coil to the spark plugs.

The spark plugs:

• change high-voltage pulses to spark at the gap, which ignites the fuel and air mixture.

The firing order is 1-4-2-5-3-6.

Fire order
1-3-4-2

Cylinder #1 will be the one closes to the fan belts and so on 1-2-3-4, on the distributor cap there should be a # 1 stamped on it, put cylinder # 1 spark plug wire on that one, install spark plug wire in firing order clockwise on the cap, the cap some time's might even have the firing order on it.

I can't upload the diagram but the firing order appears to be 1,4,6,3,2,5

Install the spark plug wire(s) (1, 3 and 5) to the engine right side spark plug(s).

Install the spark plug wire(s) to the retaining clips.

Install the spark plug wire(s) (2, 4 and 6) to the engine left side spark plug(s).

Install the spark plug wire(s) to the retaining clips.

You can get a copy of the service manual from Promanuals.net for cheap.

2003 Chevrolet Malibu 3.1L SFI OHV 6cyl
Spark Plug Wires - Removal & Installation

3.5L Engine

1. Before servicing the vehicle, refer to the Precautions Section.
   NOTE Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or the wire could be damaged.
2. Remove the intake manifold cover, if required.
3. Disconnect the left side spark plug wires from the spark plugs.
4. Disconnect the left side spark plug wires from the ignition coil.
5. Remove the spark plug wire clips from the Manifold Absolute Pressure (MAP) sensor bracket and the heater inlet and outlet pipe tab.
6. Remove the spark plug wire assembly.
7. If replacing only one plug wire, open the retaining clips and remove the appropriate spark plug wire.
8. Disconnect the right side spark plug wires from the spark plugs.
9. Disconnect the right side spark plugs from the ignition coils.
10. Remove the spark plug wire assembly.
11. If replacing only one plug wire, open the retaining clip and remove the appropriate spark plug wire.

To install:

1. Install the spark plug wire assembly.
2. Connect the right side spark plugs to the ignition coils.
3. Connect the right side spark plug wires to the spark plugs.
4. If replacing only one plug wire, open the retaining clip and install the appropriate spark plug wire.
5. Install the spark plug wire assembly.
6. Connect the left side spark plug wires to the spark plugs.
7. Connect the left side spark plug wires to the ignition coil.
8. Install the spark plug wire clips to the MAP sensor bracket and the heater inlet and outlet pipe tab.
9. If replacing only one plug wire, open the retaining clips and install the appropriate spark plug wire.
10. Install the intake manifold cover, if required.

Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system



Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 3.5L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 2.4L Engine Firing order: 1-3-4-2 Distributorless ignition system



Fig. 3.1L Engine Firing order: 1-2-3-4-5-6 Distributorless ignition system



Fig. 2.2L Engine Firing Order: 1-3-4-2 Distributorless ignition system


Fig. 3.5L & 3.9L Engines Firing order: 1-2-3-4-5-6 Distributorless ignition system


I really hope help you with this (remember rated this help) Good luck.

FROM LEFT TO RIGHT, 5/2 3/6 4/1. ASSUMING YOU HAVE THE 3.1L ENGINE.

3.9L V6 Engine. Engine Firing Order: 1-6-5-4-3-2. Distributor Rotation: Clockwise.............did i guess the right motor? let me know/rate me