I need to remove the kick panel to get to a break switch to reset it or replace it as break lights are one. model is the six cly 3.1
Kick switch is right on back of break pedal
meaning short of moving seat all way back and becoming a gymnast the brake switch should be easy to get too but there are 4 screws and 4 clips
now this where you have become gymnast two are on corners of follow bead line from steering wheel in both directions
once remove screws dont pry but gently test kick panel for play it should now slide in towards firewall and dismount
its a sensor on brake pedal there is easy adjust ment bolt before it sometimes bolts just get loose and find there way down
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: How to change the rear lights on a 2003 Buick Century.
yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much
SOURCE: Need to replace tail light bulb on 1996 Buick Century
Inside the trunk, under the carpet behind the tail lights will be a whole bunch of small plastic nuts, running from one side of the car to the other. Take all of these plastic nuts off, and the whole tail light assembly will come off in one large piece. Find the bulb you need to replace, and reassemble
SOURCE: I need to replace the 99 buick century side mirror
There is a small plastic piece (triangular shape) at the top of the door panel, opposite of the mirror. It is held in place by a plastic clip. You can gently pop that out, with a flat blade screwdriver or something similar. That will expose 3 bolts with nuts on them. On my 2000 Century, they are 10 mm. Take off those three nuts, and the mirror will come off.
SOURCE: How to remove starter 1995 buick century
the starter is located in the front of the engine near the transmission bell housing, disconnect the battery negative, the make a note (very important) of where the different wires go on the starter terminals, remove the wiring from the starter, then remove the 2 14mm bolts that hold the stater in place, slide the starter out an down, reverse to install
139 views
Usually answered in minutes!
×