When I open the door to leave the car it sounds a beeping alarm. No lights are on. I have fitted the seat belt and disengaged it but the beeps still sound. There is no alarm fitted.
SOURCE: How to open the bonnet of Hyundai i10 car
Under your dash there is a small lever with a handle and marking. pull this for ejecting the bonnet. use your palm to push off the safety lack that hold the bonnet- safety for holding on during high speed/ wind if the bonnet lack opens- to lift up your boonet. You can look through the gap of the bonnet to see this safety latch.
now on top of the engine you will see the cap for the oil inlet.
Now beffore you do that , use the dip stick to look for the oil level. wipe it and check again. Only if the oil is down you need to replace. Also topping is not required unless the engine is old/bad. otherwise it is important to change the oil filter and oil along with your service. So check this out. Good day
SOURCE: 2005 Hyundai Elantra
probably a fuse in the alarm system. BUT the car is new ,let the dealer deal with it.
SOURCE: Imobilising car alarm on Hyundai Getz
it may be worth while changing the battery in the remote as it takes more power to send the frequency to disarm than to illuminate the l.e.d.
SOURCE: My 1993 Elantra's seat belt audible/light
There is a switch in the seat belt latch that is probably worn out and it is sensing that the seat belt is not being used.
If this is a problem it should be easy to fool it into thinking the seat belt is connected by finding the wires that run to that switch and connect them together.
SOURCE: 2010 Hyundai Santa Fe How to reduce the sound of
Factory computer setting for your safety. the only way is to hack the main cars computer and reduce the volume. Best solution, put on your seat belt.
7,150 views
Usually answered in minutes!
×