Ac clutch won't engage on 2006 Saturn ion 2.2 getting power to the clutc and have ground on black wire could it be rust because I see rust on the out side of the clutch and can I take it apart and clean it or is there something I can use to clean it

Harry Goodwin

• 353 Answers
• Posted on May 23, 2009

SOURCE: Brake lights wont work, only the one in the window fuze and bulb ok

trace the wires from the brake light bulbs, there will be one that is connected to the body of the car. that will be ground

SOURCE: 2006 Saturn ion power window on driver side doesn't

the switch is bad if the switch is ok then its the motor but my money is on the switch itself.

SOURCE: 2006 saturn ion 3 won't

starter or battery

SOURCE: ac won't get cold anymore

Has the Freon been checked with a gauge to see if there is enough Freon to allow the system to work. Low or no Freon will not allow the compressor to engage. The low pressure switch is most likely activated due to low freon, and will cause this condition.

Reynaldo Andico

• 2431 Answers
• Posted on Aug 28, 2011

SOURCE: I have a 2006 saturn

Bulletin No.: 03-01-39-011B
Date: November 22, 2005
TECHNICAL
Subject:
Water Leaks Into Passenger Compartment Through HVAC Module Condensate Drain Tube When Parked on Incline/Uphill Position (Install Auxiliary Drain Tube Extension)
Models:
2003-2006 Saturn ION Sedans and Coupes
Supercede:
This bulletin is being revised to include the 2005 and 2006 model years. Please discard Corporate Bulletin Number 03-01-39-011A (Section 01 - HVAC).
Condition
When vehicle is parked on an incline with the front end up during a rainstorm or when driving uphill during a rainstorm, water may leak into the passenger compartment through the condensate drain tube opening of the HVAC module.
Cause
Water may drain out of the cowl drain, then drain down the front of the dash panel in the engine compartment and seep into the HVAC module condensate drain tube opening. The water then collects in the heater core cover and upon acceleration may leak into the passenger compartment through the heater core cover seams.
Correction 1. Open the hood and locate the HVAC module condensate drain tube in the engine compartment on the right side of the dash panel.
Important: During installation of the auxiliary drain tube, do not make contact with the HVAC module foam gasket located at the base of the HVAC module condensate drain tube. If the auxiliary drain tube is pushed on too far and makes contact with the foam gasket, water may leak into the passenger compartment.
2. Slide the auxiliary drain tube onto the HVAC module condensate drain tube and make sure that the auxiliary drain tube is angled downwards after installation.