Changed the axles and tranmision oil on a 1997 toyota tercel. the transmision is not working. The car turns but when putting it on drive and acelarating it doesn't move. It goes from D to R to N without a problem but when back to P it makes a noise. What could be wrong?
Oil level incorrect or filter or pump / torque convertor faulty
SOURCE: oil capacity
The mitchell automotive manual says if changing your filter, 4.5 quarts. Without filter, 4.0 quarts.
SOURCE: release excellorator makes clicking noise turn
Sounds like your thinking in the right area. Up on stands or hoist look for ripped boot, and/or movement at joint.
SOURCE: 1993 Toyota Tercel oil
yes no problem thse engine comsume oil a lot 10w30 is ticker then 5w30 so it will take less oil .pierre
SOURCE: 1997 toyota landcruiser colorado rear axle oil
You need to have your seal replaced. I would recommend installing new bearing while you're at it. Check here: http://www.autozone.com/autozone/catalog/parts/partsShelf.jsp?displayName=Differential+Seal+-+Rear¤tPage=1&categoryDisplayName=Drivetrain&navValue=11201715&itemId=1715-0&parentId=12-0
SOURCE: 2003 Toyota Corolla oil pressure light flickers
see if you have any oil level or pressure sensors. sometimes these can get gunked up. You may need a new oil pump. I suggest you start using a senthetic oil (valvoline,mobil 1 is reccomended) after u get the problem fixed.
165 views
Usually answered in minutes!
×