You can go to youtube and search "Torque head Bolts". They have some good videos there.
Hope this helps.
Big difference between valve cover gasket and head gasket. To replace head gasket, you must dissamble top end of engine and send the head out to be resurfaced and then install new head gasket. If it is a leaking valve cover it is much easier. Simply dissasemble and then clean valve cover and top of head from all debris and remove all old gasket material. Tighten back down in sequence and do not over tighten. these small bolts can be overtightened easily so go in sequence just like when you tighten lug nuts by skipping one as you go around. 10mm bolts require about 10 pounds or less torque.
SOURCE: 2002 NISSAN SENTRA GXE 1.8 POOR IDLE LACKS POWER IDLE FLUCTUATES BETWEEN 1800 TO 1100 RPM
Check for vaccume leaks and also you PCV valve. check the hose too. Visually inspect every vaccume hose you can find. Sounds like a leak .
SOURCE: How to replace the console light in a 2002 Nissan
Remove cover for storage bin under stereo. One hand on each side and pull towards trunk. Remove cup holder, pull up to remove shifter cover. The light is located under the shift indicator on the left. The black component will pull up but wire for light is short so use caution and try to remove light socket with out fully removing indicator. Light bulb is a #194 or peanut bulb. Pull bulb to remove. Reverse to reinstall.
SOURCE: 2003 Nissan sentra 2003 gxe, had 4 yrs, no
Start the car up when it is cold and rev the engine up for 30 seconds,loosen up the radiator cap and see if there is pressure there..If there is you probably have a bad head gasket...Caution do not open cap if engine is warm...
SOURCE: I have a 2002 nissan sentra gxe last night it just
the catalytic coverter might be cloged check o2 readings
483 views
Usually answered in minutes!
×