Blinking red l.e.d. car won't attempt to start. need wiring diagram of anti theft to see if a way around it so i can start my car
SOURCE: anti-theft system
You have to have 2 keys that are already programed in order to program another key. The procedure is cycle 2 programed keys in the ignition switch one at a time pausing 3 secs each time in the run position or until the antitheft light proves out.Then cycle an un-programmed key for 3 secs and the same for any addition key.It will have a limit of 8 keys.
If you do not have 2 already programmed keys then you have to have a scan tool that will perform security access and key programming.
SOURCE: 1997 Mercury Grand Marquis rear suspension I need
Please visit this site ..it will give you the general idea of the suspensions.
http://images.google.co.tz/images?hl=en&q=car+suspension+diagram&revid=381070573&resnum=0&um=1&ie=UTF-8&ei=uH3wSuiJNsvX-Qad4734Bw&sa=X&oi=image_result_group&ct=title&resnum=1&ved=0CBYQsAQwAA
SOURCE: wiring diagram for 1983 grand marquis alternator
i found out that it grounds when u put it on the car so u dont need to hook anything to the ground connection. the power goes to the bigger connection. the feild is usually the longer wire of the 2 wires that are left. the third goes to the sta spot
SOURCE: 2003 ford ranger theft light blinking and won't start
the anti-theft has been activated and needs to be reset.you may have to get it to a shop that has the tools to do this or go to the dealer to get it done.did you use a key that was cut as a spare and doesn`t have a chip in it.this usually can cause this.also if the wires at the switch break it can activate the anti-theft system.
583 views
Usually answered in minutes!
×