SOURCE: replace rear seat belt in 1993 Toyota Corolla
OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).
SOURCE: How do I change the thermostat on my 1993 Toyota Corolla DX
Follow your upper rad hose to where it connects to your upper of part of your engine. It should be be easy to spot the expanded housing that the hose goes to. it's in this housing. Hope that helped.
SOURCE: toyota corolla 1.4 vvti cluth problem
try to give it a little gas when letting the clutch out
SOURCE: i need to know where the egr valve is located
EGR stands for EXHAUST GAS RECIRCULATION.
This is a loop back system between your exhaust manifold and the underside of your filter.
The EGR valve is located between the inlet (exhaust manifold) and the outlet (intake manifold).
About 8-12" below the air filter....toward the passenger side.
EGR carbon built up can be clean.
Check the soft membrane on the EGR valve and see is it crack/torn. If it's in good shape then you may reuse it.
The professional use a vacuum hand tool to determine the travel of the EGR.
There are carbon built up inside the EGR air passage tube too,
Make sure you give both a good cleaning.
The EGR base gasket MUST BE REPLACE!
Order one before you start the job.
Please post more info on the comment window.
101 views
Usually answered in minutes!
×