Then put it in park the driver door don't unlock Have too roll down window use the key power locks won't work when this happens
If the interior door handle doesn't open the door, then you have a push bar loose or bent inside the door. If once you unlock the door from the outside you can use the interior door handle to open the door, then you either have a bad lock unlock relay, or the door lock unlock actuator itself is bad.
SOURCE: 2004 tahoe
yes or damage to the cars computer chances are that you have a blown fuse or loosecables check all connections and be very careful not to damage any airbag cables
SOURCE: power locks not working right
Hey, this might work.....get in truck, close doors, put key in ignition in lock position.....hold down the door lock button on driver side door control and wait for the lock control to be displayed on the information screen(odometer read-out).....it should say like lock 1, lock 2, lock 3, lock 4.....or something, I always reset mine to LOCK 1, to do this hold the odometer reset button on dash for a sec or two til it changes settings, then release, repeat till you get to LOCK 1, then quickly press and release odometer reset button to exit program, this is the function to lock doors over 15 mph and when out of park and to unlock doors when returned to park......yours' might be set to another function number....try it out, let me know if this helps.........good luck!
SOURCE: door locks and power window
Just did this procedure I got from coloradofans.com forums:
"any type of power/voltage change
seems to trigger this issue
The most common symptom is power
locks fail and only the driver window quits, however that is on the
extended cab.
Steps to fix and it works every time.
take
door panel off driver's door
Disconnect the wiring attached to window
and power lock control unit
disconnect battery cables
connect
the negative to the positive cable(((NO BATTERY CONNECTED)))
This
will act to short residual voltage in the system
5 minutes later
place
the key in the ignition and turn to the run position
connect the
wiring to the window/lock controller
connect the negative cable to
the battery
then the positive
open drivers side door
turn key
to the off position((do not remove yet)) you should get a series of
dings through speakers telling you the key is still in the ignition
once
it begins dinging pull the key out and you should hear the door lock
solenoids trigger and the windows should work." - Coloradofans.com forums
SOURCE: Switches on the front passenger door quit working.
We have the EXACT same problem. Can anybody help with this?
232 views
Usually answered in minutes!
×