How to remove front door card fabia 2005 - 2005 Skoda Fabia

I would post that question on the Skoda forum:
http://www.briskoda.net/forums/forum/166-skoda-fabia-owners/
Skoda Fabia Owners

dear. first wan know which engine . 1.6 or 1.4 / 1.2
if 1.6 you need to remove oil pan and clean oil pump pipe
1.4 you need to check con.rod bearing condition .mostly replace with oil persure sender.
1.2 you need to clean oil filter housing with O ring

dear. please check the rear brake lights if its working .if not replace rear brake light s.w

1st off remove the plastic moulding inside of the door release ,undo the small screw,at the bottom of the door there are 4 screws[usually pozy drive] undo them, prise off the bottom part of the cover [the door pull arm]inside there is a large pozy screw,undo that,then using a medium screwdriver or a small pry bar placed between the door panel/door,prise away the panel section by section,beginning from the bottom,until you have unclipped all the plastic retainers,then gently lift away upwards,do not drop,as you have to unclip the door release cable from the back of the door panel,making sure to remember how it is sitting on the door panel and the lever,so to ease the re-assembly.

need to replace driver door lock ,

A bit more information needed i'm afraid is the door jammed or just will not unlock when using the key fob ??

first remove the handle cover two cove . the small one with s.w if electric power window . or same cove use screw driver . second step move big cove to front side it will remove easy . two bolt in side with screw drive .then remove small cove( side mirror handle cove ) near door opener . small bolt inside .then 3 bolt under the panel
the force the clips out

electronic power control , check rear brake light if its not working when apply brake , replace brake light S.W it will remove out

1. Remove the front door trim panel.
2. Remove the front door watershield.
3. Secure the front door window glass in the full upward position with tape.
4. Remove the front door window glass-to-regulator assembly bolts.
   • Loosen the glass clamp fasteners through the 2 vertical slots in the inner door panel.
   • To install, tighten to 9 Nm (80 lb-in) .
   1. Disconnect the front door window electrical connector.
   2. Remove the front door window regulator bolts.
   • To install, tighten to 11 Nm (8 lb-ft) .
   1. Remove the front door window regulator and motor.
   2. To install, reverse the removal procedure

adviced to meet a specialist or mechanic