How to locate a camshaft sensor for a nissan almera tino

SOURCE: Nissan Almera Tino Diesel 2.1 - Temperature control not working

Hi there, very common on these vehicles, you need to remove the heater cotrols and check that the cable hasn't come out, usually the clips that hold the cables in place break causing the heaters to not work properly, Nissan do modified clips now to stop it from happening, it may need a cable too if its too far bent, hope this helps.

HyeProfile

• 35 Answers
• Posted on Aug 05, 2009

SOURCE: sensor locations

Here's the diagnostic procedure for DTC code 0340, directly from the service manual:

SOURCE: Radio says Secure on Nissan Almera Tino (04)

Your radio believes that it has been stolen out of the car since battery power was lost to it (as a result of the car battery going dead). There should be instructions in the user manual on how to reset the radio.

SOURCE: how to find the heater resistor for a nissan

the majority of heater resistors are on the heater box under the passenger ide of the dash, on some very few models it is part of the actual ac control panel

SOURCE: how do I remove the service spanner symbol from a

Try this: With the ignition ON but radio OFF, press in and hold the INFO button and turn volume control until the menu appears. Now choose CONFIRMATION and Enter. Go down and select SERVICE and press Enter. Select RESET and then Enter. Backup to the main menu and now turn ignition off. This should remove it.