SOURCE: electronic flasher
It is in the fuse panel. Open your front car door and you will see a panel on the outside edge of your dashboard (hidden when the door is closed). That is where the fuses are and it is the big square fuse in the center.
SOURCE: 1988 corsica turn signal flasher unit
Look under Driverside Dash under Steering wheet find the Plug for Scanner then go straight UP from there It Should Be Cliped to A Bracket DIRECTLY ABOVE THE DIAGNOSTIC LINK PLUG Its Ther Just Hunt for it sometimes People change them and DONT Put EM BACK
SOURCE: Where does the flasher go on a 98 chevy malibu
Replacement
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressure at the retaining clip points . . .
. . . then gently pull the accessory trim plate away
Detach the electrical connector from the hazard warning switch.
Unplug the electrical connector from the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Testimonial: "just what I needed, thank you so much."
SOURCE: 91 Chevy K5 Blazer turn signal flasher
i agree with them, but you know when you open the door and thatgod damn buzzer goes off until you turn on the truck? how the hell do you shut that off?
please email me [email protected]
thanks
231 views
Usually answered in minutes!
×