SOURCE: How to replace headlight bulb hyundai elantra 2004
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
SOURCE: my 2000 Hyundai elantra and all the gauges, radio, etc quit and
your charging system is not working,so your car is working only on batt. power,when batt.gets weak car will cut off! good chance alter nator is defective! check alt.elect. connections at alt,if con.are good its alt.
SOURCE: How to replace 2004 Hyundai Elantra starter
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
SOURCE: what is meaning p1529 on my elantra
P1529 means the TCM (transmission control module) has requested that the ECM (engine control module) turn on the check engine lamp. All I can tell you based on this information is that the TCM has seen something abnormal. To find out what abnormal condition the TCM saw, you'd need to retrieve the DTCs (diagnostic trouble codes) from the TCM. The most frequent culprit is either the input or output speed sensor, but there's no way to know whether they may be the issue without the TCM DTCs
68 views
Usually answered in minutes!
×