Location of blower motor resistor on a 2001 pontiac bonneville?

SOURCE: i'm looking for the location of the resistor on

jrp8978 is right about the location but I have a 99 and I did not have to remove the blower motor

Marvin

• 85242 Answers
• Posted on Nov 12, 2009

SOURCE: Where is the blower resistor located on a 2008

The blower control module also known as the blower motor resistor is on the passenger side of the firewall in the engine compartment near the blower

Testimonial: "Thank you! You saved me hours of searching under the dash for something that was under the hood! Thanks again. Bill"

ZJ Limited

• 17989 Answers
• Posted on Mar 26, 2010

SOURCE: need location on blower motor resistor on 1994

Fig. 1: The blower motor and fan assembly is mounted in the heater and A/C module, and is accessible from the engine compartment

GM Bonneville/Eighty Eight/LeSabre 1986-1999
Blower Motor - REMOVAL & INSTALLATION
(see Figures 1 and 2)

1. Disconnect the negative battery cable.
2. If necessary, tag and disconnect the number 2, 4 and 6 spark plug wires from the ignition coil and move the coil out of the way.
3. For 1993-99 vehicles, remove the nuts and cross brace bar.
4. Detach the electrical connections from the blower motor.
5. Disconnect the cooling tube from the blower motor.
6. Unfasten the screws securing the blower motor to the blower module assembly.
7. Remove the blower motor and fan assembly from the module.
8. If necessary, unfasten the nut attaching the fan to the blower motor shaft, then pull the fan from the blower motor.

1. If the fan was removed from the motor, position the fan on the shaft, then install the retaining nut. Tighten the nut to 12 inch lbs. (1.4 Nm).
2. Position the blower motor and fan assembly to the module, then install the retaining screws. Tighten to 5 inch lbs. (0.6 Nm).
3. Connect the cooling tube to the blower motor.
4. Attach the electrical connector to the blower motor.
5. On 1993-98 vehicles, install the cross brace bar and retaining nuts. Tighten the nuts to 18 ft. lbs. (25 Nm).
6. If removed, install the coil and connect the spark plug wires, as tagged during removal.
7. Connect the negative battery cable.

SOURCE: i need the location of the blower motor resistor

On the top of the A/C/ Blower motor evaporater box. You will see two screws holding it in with 4 wires going to it

SOURCE: 2001 Grand Prix: Is the blower motor resistor on a Pontiac 2001 Gra...

It is behind and underneath the glove box back by the firewall. No need to pull out the glovebox.You may need to pull the carpet back to get to one of the bolts.