Get your car fix right now
2006 Ford Five Hundred Workshop Repair Service Manual PDF Download
SOURCE: 1998 Ford Explorer sport 4.0L 4x2 PCV Valve Location
the pcv is located on the rear(firewall) of the drivers side valve cover.turn counterclockwise and pull to remove be careful there are 2 small tabs inside the pcv hole in the valve cover(can feel with small finger) this is to hold valve in place so it wont leak.if you have a oil leak at the pcv a quick fix is to put a small amount of silicone around the pcv o-ring and install.wait hours for silicone to set up.
SOURCE: pcv valve :where is it located on a 1999 ford explorer sport 2wd
It is located at the back of the engine near the fire wall. It is gray with a T connector at the top with two hoses coming off of the T and going forward into the intake manifold.
SOURCE: 2006 Ford Five Hundred -- Where's the fuel filter?
right rear just in front of wheel. push clips back and remove old filter. apply new filter insuring flow is correct direction by arrow on filter press the clips back in place and you are ready. check to see if it is leaking.
SOURCE: What is the location of the PCV valve on a 2005
Its in the back of the intake.It points straight towards the windshield way.It has a black hose that comes off from it..If your standing in front of the car looking down at the motor at the middle of the motor look straight back and down just after the intake starts to round down you'll see it..
I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_a3369546f8067589
SOURCE: location of pcv valve on 03 ford focus
http://www.focushacks.com/images/pcv.jpg
Here's a picture to locate it..
So, when looking at the engine from above, on the right of the exhaust.
Procedure to replace it
1) Lift and support the front end of your car, or drive up on ramps
2) Get under the front of your car. The PCV Valve is located behind the exhaust manifold, a few inches below the valve cover.
3) Push up on the PCV valve to pop it out of the tube, or pull. You can get it out of the rubber tube with some effort.
4) Remove the rubber elbow from the top of the PCV valve. This can be re-used if it's not squishy. It can also be replaced cheaply.
5) Put the elbow on the new PCV Valve
6) Re-attach the elbow to the PCV tube
7) Push the new PCV valve back down into the large rubber tube
2,706 views
Usually answered in minutes!
×