How to reset oil change light on 2008 bmw x3 3.0si
SOURCE: i had my 2003 BMW M3 in for it's annual oil change
1. Key in 0 or off position.
2. Press and hold odometer button and turn key to 1 or acc. position... like you're turning the car on, but don't crank the engine.
3. Keep button pressed until any of the following words appear in
display: "oil service" or "inspection", with "reset" or "re". For
vehicles with "high cluster", the fuel amount (in litres) remaining
until next service is displayed (i.e. 3224).
4. Press and hold button again until "reset" or "re" flash.
5. While display is flashing, press button briefly to reset service
interval indicator. After display has shown new interval, the following
will appear in display for approx. 2 seconds:"END SIA"
SOURCE: I would like to know how to reset the oil change indicator on a 1994 BMW 318i
Switch on ignition.
Earth terminal 7 (I've no pic sorry) and hold for 3 seconds.
Switch ignition off
That should do it
SOURCE: Reset ''Service Oil'' sensor on a 1985 BMW 325E off dash console
Call your local BMW dealer and ask them...should be free!
Good Luck
SOURCE: reset warning lights BMW 325
make abs sensor is properly plug in if they are not you will see that light
SOURCE: oil change reset for bmw 525i
You only need to hold the left odometer reset button while turning the key to position 1 (Accessory). Keep holding the button for 5 or so seconds until any of the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE. Release the button and press it again for another 5 or so seconds until RESET or RE flash. While the display flashes, press the button one more time briefly. If done correctly, END SIA should show up for a few seconds. All done.
Thank you for using fixya
1,020 views
Usually answered in minutes!
×