There are 2 either 10 mm or T30 torx head bolts around the armrest. They are semi hidden so you have to peek down holes. The rest is held on by plastic clips, there is a special tool for these, you have to feel between the trim panel and door till you find them and pry carefully. 1 of the bolts may be under the switch panel if its a front door
SOURCE: remove door panel
Remove the screws and lift up. There aren't any screws behind the window switch, it is screwed on from behind. There is a hidden screw behind the lock slider.
SOURCE: driver side window won't go up
To removethe window motor,Using a common screw driver go around the panel prying out the clips that hold the panel on.Be careful not to pull clip out of panel.The motor may have pop rev.or bolts holding it in.If pop rev.,you will have to drill them out,replace with bolts.
SOURCE: HOW DO I REMOVE DOOR PANEL
On the inside trim, you can remove screws (these screws may be covered by filler pieces or may be visible, or they may require you pry a plastic piece off that covers the screws) that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls.
SOURCE: my back speakers on my trailblazer 2007 ls sometimes does'ntwork
make sure there pluged in if so you need to get new ones
Testimonial: "answered in details"
SOURCE: How do I remove the driver's door panel on a chevy 2007 nbs?
open door pull ruber boot back on door side unplug wire connections snap lock release on con pull pins pull door
624 views
Usually answered in minutes!
×