SOMETIMES THE TRUCK WONT START, WAIT 10 MIN THEN IT WILL START
SOURCE: towing capacity for an Isuzu I370 pickup
As listed in the owners manual.
Weight of the Trailer
How heavy can a trailer safely be?
It depends on how you plan to use your rig. For
example, speed, altitude, road grades, outside
temperature and how much your vehicle is used to
pull a trailer are all important. It can also depend
on any special equipment that you have on
your vehicle, and the amount of tongue weight the
vehicle can carry. See “Weight of the Trailer
Tongue” later in this section for more information.
Maximum trailer weight is calculated assuming
only the driver is in the tow vehicle and it has all
the required trailering equipment. The weight
of additional optional equipment, passengers and
cargo in the tow vehicle must be subtracted
from the maximum trailer weight.
The following charts show how much your trailer
can weigh, based upon your vehicle model
and options.
2WD Extended Cab Axle Ratio Maximum Trailer Weight GCWR*
Automatic Transmission,
2.9 L Engine 3.73 3,100 lbs (1 406 kg) 7,000 lbs (3 175 kg)
Manual Transmission,
2.9L Engine 3.73 2,100 lbs (952 kg) 6,000 lbs (2 721 kg)
4WD Crew Cab Axle Ratio Maximum Trailer Weight GCWR*
Automatic Transmission,
3.7L Engine 3.73 4,000 lbs (1 814 kg) 9,000 lbs (4 082 kg)
*The Gross Combination Weight Rating (GCWR) is the total allowable weight of the completely loaded
vehicle and trailer including any passengers, cargo, equipment and conversions. The GCWR for your
vehicle should not be exceeded.
SOURCE: Hi,
If shifting into neutral works you may have a damaged parking safety switch. Some vehicles have one for neutral and one for park.
Be sure to check your battery and starting system too. A weak battery or worn starter solenoid are also likely causes.
Good luck and be careful!
SOURCE: 1995 isuzu pickup wont start sometimes
Fuel Pressure Regulator is located on the fuel rail. 1. Disconnect the negative battery cable. 2. Properly relieve the fuel system pressure. 3. Remove the air cleaner outlet tube(s). 4. Remove any necessary components to access the pressure regulator. 5. Disconnect the vacuum hose from the pressure regulator. 6. Remove the pressure regulator attaching screws. 7. Remove the pressure regulator from the fuel rail. To Install 8. Discard the O-rings on the pressure regulator and replace them with new ones. 9. Lubricate the O-rings with clean engine oil. 10. Install the regulator into the fuel rail and tighten the retaining screws. 11. Connect the vacuum hose to the regulator. 12. Install any components removed to access the regulator. 13. Install the air cleaner outlet tube(s).
385 views
Usually answered in minutes!
×