I recently had the oil change and the service indicator was not reset
Hi If I was you I would take it back to where you had car servised from,and get them to reset service idicater as these normerly need to be reset by some one with a electronic tool.hope this was some help,If you did oil change yourselve then you can buy the tool on e-bay under diagnostic tools good luck.
SOURCE: reset the service indicator light - 06 Toyota Sequoia
set the mileage when the odometer is showing. put the key to off position. press and hold the reset button then turn the key to on position, do not start. then continue holding the reset button until the reading stops to zero or blank. turn it off, that should reset the light indicator
Testimonial: "thanks for the help! it worked like a charm. appreciate it! "
SOURCE: Where is the reset button to reset the service
Here's how you get reset the MAINT REQD light:
1) put the key to the ON position
2) press the mileage reset button on your cluster so it shows total mileage (not trip)
3) put the key to the OFF position
4) press and hold down the mileage reset button, leave it pressed
5) put the key to the ON position
6) wait until the mileage shows 000000 and you can stop pressing the ODO button
If that doesn't work, consult this
http://www.tundrasolutions.com/forums/tundra/115807-reset-maint-reqd-light/
Testimonial: "Thanks very much. I'll give this a try."
145 views
Usually answered in minutes!
×