How to remove northstar engine 2002 caddilac deville

Gary Queen

• 85 Answers
• Posted on Nov 12, 2008

SOURCE: SETTING TIMING ON 2000 NORTHSTAR ENGINE

Setting the camshaft timing isnecessary whenever the camshaft drive system has been disturbed,meaning the relationship between any chain and sprocket has been lost.Correct timing exists when the crankshaft and intermediate shaftsprocket timing marks are in alignment and all 4 camshaft drive pinsare perpendicular (90 degrees) to the cylinder head surface.

degrees) to the cylinder head surface. I hope this helps, if not let me know

SOURCE: radiator replace

I Hope you Find this Helpfull And Please Remember to RATE ME

1. Drain the coolant.
2. Disable the SIR.
3. Move the forwarding discriminating sensor out of the way.
4. Remove the air cleaner assembly.
5. Remove the cooling fans.
6. Disconnect the radiator inlet hose from the radiator.
1. Disconnect the radiator outlet hose from the radiator.
2. Disconnect the engine oil cooler lines from the right radiator end tank.
3. Disconnect the transmission oil cooler lines from the left radiator end tank.
4. Remove the left and the right engine torque struts.
1. Remove the upper radiator support screws.
2. Remove the radiator from the vehicle. Lift the radiator up and out. INSTALLATION PROCEDURE
1. Install the radiator to the vehicle.
2. Install the upper radiator support screws. Tighten the bolts to 6 Nm (53 inch lbs.). NOTICE: Refer to Fastener Notice in Service Precautions.
3. Install the transmission oil cooler lines to the radiator. Tighten the transmission oil cooler line fittings to 27 Nm (20 ft. lbs.).
4. Connect the engine oil cooler lines to the radiator. Tighten the engine oil cooler lines to 18 Nm (13 ft. lbs.).
5. Install the left and the right engine support torque struts.Connect the radiator outlet hose to the radiator.
1. Connect the radiator inlet hose to the radiator.
2. Install the cooling fans.
3. Install the air cleaner assembly.
4. Install the forward discriminating sensor.
5. Enable the SIR.
6. Refill the coolant.
6. Hope this Helps and PLEASE RATE ME

SOURCE: how to change a thermostat on a 2002 cadi deville

Follow the upper radiator hose to the point where it enters the motor. Disconnect it at that housing and remove the bolts holding the housing in pace. Remove the housing and all of the old gasket. The thermostat sits under that housing and just pops right out. Install the new one along with a new gasket. Put everything back in the reverse order.

SOURCE: battery removal 2000 cadillac deville

Its on passenger side under rear seat cushion. Get in back seat FACING rear seatback, grab under lip of bottom seat cushion, and pull straight up. Disconnect seat heater connector (if so equipped) on passenger side and remove seat bottom. Tada! There ya go! Oh... btw. Its a $150 battery due to the venting system designed into it to vent fumes through a tube to the outside world. Thanks Cadillac!!! :(

SOURCE: how to remove the water pump pully on the 4.6

you don't, the water pump has pulley built in. (it's located on the driver's side in the rear of the engine in case you mis-understand that it's on the front of the engine )
there's a special tool to remove and install the water pump.
if you have the tool the the job is very easy