1998 Jaguar XJ8L Logo

Related Topics:

A
Anonymous Posted on Jul 06, 2014

Where is the oil pressure sending unit on a 1994 van den plas 4.0 engine

4 Related Answers

Anonymous

  • 2 Answers
  • Posted on Jul 03, 2008

SOURCE: 1998 Jagual XJ8L Van Den Plas

Mine the same, done timing chains and tensioners, gas analyser shows it to be running rich on one bank only, swapped injectors with other bank and changed all 'o' rings. Isn't running rich when revs above 1500 so think it may be VVT on one cam, removed solenoids and found shuttle valve sticking in on one side, shuttle springs back out on other bank, going to replace in near future, maybe you have same problem, get exhaust gasses analysed to find if one bank running rich when idling.

Ad

Anonymous

  • 82 Answers
  • Posted on Jan 20, 2010

SOURCE: where is the fuse in the 2001 jaguar van den plas

trunk fuse box....position 5 25 amp fuse

Ronnie Wilson

  • 1596 Answers
  • Posted on Oct 20, 2010

SOURCE: where is the battery located on a 1994 Den Plas

In the TRUNK /BOOT , Under Rear Seat, or DEEP Under Components In the ENGINE COMPARTMENT, A HIDDEN COVER Is Whats Making it Difficult to Locate

Anonymous

  • 42 Answers
  • Posted on Apr 10, 2013

SOURCE: what does code p1111 mean on a 1999 jaguar van den plas

P1111 Intake Air Temperature (IAT) Sensor Circuit Intermittent High Voltage

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Where is the oil pressure sending unit on a 1994 ford thunderbird 3.3l

Well first off they never used a 3.3 Liter engine in the 1994 T-Bird. The oil pressure sending unit is located near the oil filter under the car.
0helpful
1answer

Ford aerostar troubleshooting

It could be any number of things, most likely cause is you have a oil sending unit that is wore out and giving false readings. Either buy a new sending unit and change it out or hook an oil pressure tester to your engine and check the oil pressure.
I'd buy a new sensor and replace it myself, because the vehicle is 23 years old and probably the original sending unit, besides the oil sending unit has to be removed in order to check pressure with mechanical gauge anyway.
0helpful
1answer

My 2006 gmc savana 2500 is losing oil pressure

Unless you have run it out of oil a few times. replace the oil pressure sending unit. I am assuming you have an eight cylinder in the van, so the sending unit is on the back, top of the engine. About 3" long and 1 1/4 " in diameter
0helpful
1answer

Where is the battery located on a 1994 Den Plas

In the TRUNK /BOOT , Under Rear Seat, or DEEP Under Components In the ENGINE COMPARTMENT, A HIDDEN COVER Is Whats Making it Difficult to Locate
0helpful
1answer

Where is oil pressure switch in chevy lumina van 1996?

To locate the oil pressure sending unit, locate the oil filter and look above it and to the right, above the starter. You will see a long round sensor, this is the oil pressure sending unit. It screws into the engine block and when you remove it you will get a dribble of oil.
1helpful
2answers
8helpful
1answer

Location of the oil pressure sending unit 1994 accord 4 cylinder

The oil pressure sender is above or below the oil filter, threaded into the side of the engine block.
Hope this helps you.
2helpful
1answer

Oil pressure gauge not reading on my 1994 jeep wrangler. oil is full just the guage has no pressure and not alot of power

The oil pressure specification for your engine is 13 PSI at idle hot, 37 to 75 PSI at engine RPM higher than 1600. I suspect your oil pressure gauge sender unit or gauge is inaccurate. I would have a known accurate mechanical oil pressure gauge temporarily screwed into the present oil sender unit to verify actual pressure.

If you have the correct pressure I would replace the sending unit first.
0helpful
1answer

1998 Jagual XJ8L Van Den Plas

Mine the same, done timing chains and tensioners, gas analyser shows it to be running rich on one bank only, swapped injectors with other bank and changed all 'o' rings. Isn't running rich when revs above 1500 so think it may be VVT on one cam, removed solenoids and found shuttle valve sticking in on one side, shuttle springs back out on other bank, going to replace in near future, maybe you have same problem, get exhaust gasses analysed to find if one bank running rich when idling.
Not finding what you are looking for?

74 views

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...