Stalls while driving and will start up again after along wait
SOURCE: chrysler voyager 2.5 diesel cuts
Hello again,
I commented yesterday that I had the same problem and had done some tests in an attempt to identify the cause.
I contacted a local mobile mechanic, and when I described the symptoms, explained the tests that I'd carried out, and told him of my theory that the fuel filter might be partially blocked he said, "Yes, I'm sure you're right. I've had to do 14 Voyagers in the last month with the same problem!" Hopeful that he was right, but still a bit sceptical because the car had a service less than a month ago in which the fuel filter was listed as one of the replaced parts, I called him out. He came, removed the old filter, commented that "The old filter is really dirty and doesn't look to have been replaced for at least 25,000 miles!" inserted a new filter and the car has been running perfectly since. There's a marked improvement in the way the engine's running (not really surprisingly!) and this reinforces my belief that most (but not all) garages are only interested in taking your money and not doing the work.
For anyone interested, the process of replacing the filter was relatively straight forward and I think (if I ever have this problem again) I will replace it myself. On my Voyager (2001 RHD UK spec 2.5l TD) The fuel filter is located in the rear fuel pump, situated just forwards of the rear axle, on the driver's side of the fuel tank. The filter is removed by using a spanner of about an inch. Note, once the new filter is inserted it's important to prime the engine well before starting it otherwise it will need to be bled (which is apparently a tricky job on the Voyager!) To prime the engine and get fuel through before starting it, you must turn the key in the ignition so that you hear the pump working (eventually the pump noise should stop), and repeat this several times (we did it about 10 times) before turning the key further to turn the engine over. This process makes sure that there's a constant stream of fuel through the new filter and up to the front where the engine is!
That's all the mechanic did, and it worked! Even my wife's happy (of course all things are relative!)
Hope this helps,
Richard.
SOURCE: 1992 Chrysler LeBaron 3.0 L.
the owner probably rerouted the fuel line because like my 92 chrysler lebaron v6 3.0 the fuel lines keep seeming to come off and the clamps always break. I have replaced the clamps 5 times in a month and replaced filters 2 times in 2 months. The only thing i could think of is that your fuel is being cut off possibly because there is no filter to clean all the junk out. Try putting a fuel filter on and see if that will work
SOURCE: what is a engine code 55??
Code 55 means 'End of code read-out', but not actually giving you any errors.
Seems to me though that it may have something to do with the fuel pump seeing as banging the fuel tank made it work for a little while.
To find the real problem have a dealer or mechanic troubleshoot.
SOURCE: fuel filter for 2001 chrysler concorde
for the most part it on the driver side under the car close to the frame of the passenager side just in front of the rear tire in the frame also checkout this website to see if they have your car listed its www.autozone.com if they do you be able to get pictures and diagram showing you where its located on your car.
254 views
Usually answered in minutes!
×