SOURCE: remeove rear combination tail light cover 2006 Nissan XTERRA
I just changed out a tailight on my 2000 Nissan Xterra, so I assume it may be similar. You have to pop the plastic strip which runs across the back. There are pop rivits in it.
SOURCE: 2000 Nissan Xterra Service Engine soon indicator is always on
The knock sensor is not a huge deal to replace and will not turn on the light. It should be dont though.
The crankshaft sensor is located directly between the engine and transmission. It is dead center at the bottom.
SOURCE: I have been told that I have a valve cover leak.
You can do the repair yourself. Your valve covers leaking will result in you losing oil because it's not making it's way to the oil pan. You probably won't hurt the engine if you keep the oil level constant, but you can replace the gaskets yourself. It's a bit of a job, but not too bad. You'll proably have to remove the intake manifolds and replace these gaskets before the valve covers. The valve covers are just plastic covers for the valves-one big box. Put new gaskets in place and reinstall the reverse of removal.
SOURCE: 2000 nissan xterra knock senor and plug 5
Have you changed all the plugs to platinum and wires? My xterra was doing that and I changed all of them and now it runs great. Also, I changed the distribitor cap and rotor button.
SOURCE: i am remove heater core from nissan xterra 2000 do
2000-02 Frontier And Xterra
CAUTION
Wait 3 minutes after disconnecting the battery cables and turning
the ignition switch to the OFF position before servicing the air bag
system.
CAUTION
Always store the SRS module face up.
CAUTION
Wait 3 minutes after disconnecting the battery cables and turning
the ignition switch to the OFF position before servicing the air bag
system.
CAUTION
Always store the SRS module face up.
continue...
201 views
Usually answered in minutes!
×