How do i change the headlight bulb on the drivers side of my 2007 Hyundai Entourage?
You need to remove the battery, and then to access the light bulb, unscrew bulb covers. If not accessible, remove headlight assembly with five mounting screws. Two on top and three below
You have to take the black plastic top off under the hood on the front.....than you take the whole headlight out, I believe it's only two bolts...there is opening for each light and they are pretty simple to change.
SOURCE: Headlight bulb replacement for 2002 Hyundai
http://www.autozone.com/autozone/repairinfo/common/repairInfoMain.jsp?targetPage=productsHowToInspect&leftNavPage=productsHowTo&pageId=%090900c15280213e7e&subtitle=replace
SOURCE: how do i change right headlight bulb on a 2007
You change it like you'd change any headlamp bulb. There is an access cap behind the headlamp assembly -- remove it, then remove the connector to the bulb, then remove the retaining clip/spring holding the bulb in place. Then install/insert the new bulb in the same 'ORIENTATION' as the old one. Reinstall in reverse order... ALAKAZAM!... .done!
SOURCE: How do I change the headlight bulb in a Hyundai
I changed a Right Front low beam bulb this morning on a 2007 Entourage. You have to remove the two bolts on top, use a 10mm socket, then you wiggle side to side and pull the entire headlight assembly forward. The headlight gets caught a little behind the grill so you have to pull sideways a little then forward with a little force. I heard some scraping plastic but nothing broke. Then you remove the black round cap in the back and change the bulb.
SOURCE: How do I change a headlight on a 2007 Hyundai?
I thought I removed all of the bolts - a total of three (3) - but there are actually four (4), including one (1) inside, next to the radiator. It is difficult to see, and a pain to remove, but once out, the assembly can be easily removed.
SOURCE: side light bulb change on hyundai terracan
hi there
the solution is simple,
you only need to undo the screw on top of the side light/indicator. then facing the head light place a flat headed screw driver under the bottom lip of side light. the bottom of the lihgt is on a small push fit stud, use a sponge or cloth to protect your bumper paint work then just apply pressure gently to lever side light out towards you, It will come dont worry, you may then change your bulbs if you wish remove the whole light unit you will see the bottom bolt as soon as you release the side light. to replace just push back into place then replace screw. whole job takes about five minutes
hope this helps kevan hildred
666 views
Usually answered in minutes!
×