Clutch padel has gone to the floor n i cant get gears

check that you have fluid in the master reservoir. Bleed air from the clutch system.

adjust the clutch padel

purchase a clutch cylinder rebuild kit. cost around 15-20 bucks. drain and remove the clutch master cylinder. replace the o-rings and other parts proveded in kit.

The pilot bearing is the input bushing,this has nothing to do with the cable going to the floor and staying there,The clutch calbe is adjustable . You adjust it by pulling on the cable and leave a 1/4 freeplay your problem is you need to adjust the cable

It could need a clutch. Try pulling up on the clutch petals to see if it will self adjust.

?. Did you bench bleed all of the air out of the 2 master cylinders before installing on your vehicle, it sounds like that it has air in the sysytem, try bleeding the cltch master cylinder and the bleed off the slave cylinder, that should put you on par.

check your sleeve cylinder on gear box it much be leaking,and i think you clutch is gone.sounds like your thrush bearing is also gone.

It's possible the master cylinder could be it, if it were the slave cylinder you'd be losing clutch fluid.. Are you losing the fluid too?

I think you have Check Gear Shift Liver Lock System. Then You have to check Brake Padel Switch because you can move gear shifter by pressing brake padel. Is your brake Padel switch defect stuck in any position.

maybe it lost all the fluid as may be leacking from slave cylinder the carpit will be wet with fluid or the slave cylinder could be gone in that case the bellhouseing on the gear be will be wet with fluid or at least the thrust bearing could have gone thought the clutch cover