SOURCE: Traction Contrl and ABS Light on
No, it is probably not related. Usually the ABS and traction control light is either a wheel sensor problem, located in one of the wheel bearings, or most likely in the wire harness from the wheel bearing sensor. Remove wires and spray clean with a good solvent electric spray, and check the condition of the receptacle. I have had these problems with my 02 AWD so many times it has become almost routine. GM really have a problem with this type of speed sensor in the wheel bearings. In the AWD model, it keeps the car in FWD if the ABS light is on for any reason. JUNK!
SOURCE: jump start 2000 venture
In order to reach the negative terminal to the battery in a 2000 Vebture (I have one) you must first remove the fuse housing. The fuse housing is a large black box that sits atop the battery. There os a single bolt that holds it in place located in fron of the battery bolted into the lip of the motor bay. Unscrew this, then unhook the fuse housing from the cross bar running from the back roght to the front of the motor bay. This is a tight fit so watch your knuckles. Once the fuse housing is out, the negative terminal is located on the backside of the battery. It is a tight squeeze black is negative, red is positive.
SOURCE: how do you reset power sliding door on 2000 chevy venture
there should be information in your owner manual telling you how to do it if you have miss place your owner manual try this website to see if you can down load one for your car its www.edmunds.com and i hope i was able to help you Michigan Man
SOURCE: need to add 13-4a freon to my 2000 venture chevy van. Where is the pressure hose located?
passengers side under the hood.....by the firewall.....
SOURCE: ABS TCS lights on Chevy Venture 1999
Have your brakes inspected. Wear may have reach the attention point. Good Luck
161 views
Usually answered in minutes!
×