Delco how to install 24239240 lever - 2013 GMC Acadia

http://www.mobileinformationlabs.com/delco-stereo-wiring-diagrams.htm

http://www.autos.com/aftermarket-parts/understanding-the-wiring-color-codes-for-delco-car-radio-units-and-accessories


wiring harness color code Delco 30015807

think you can get an adaptor from car shop ?, just plugs in.

The only spark plugs that should be in your car are a/c delco's. The ones you installed have no adjustable gap which is not good. Replace the plugs with the o.e. a/c delco plugs. Clear the code and see what happens. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

http://www.delcoremy.com/Documents/Alternator-Instruction-Sheets/24SI-installation-instructions_10513391.aspx

check for a mute button on the delco

First of all,you will need the Northstar waterpump removal tool, You can get this from most reputable auto part stores and looks like this :-



The following link shows a selection of different manufacturers.


http://www.bizrate.com/automotive-repair-tools/northstar-water-pump/

You need to remove the air filter housing and ducting to gain easy access to the pump.

Remove the shield covering the pulley and belt. The belt is easily removed by levering the tensioner pulley.

The water pump is located at the lower radiator hose manifold where you will also find the thermostat.Remove the manifold cover and you will see the water pump.

Insert the removal tool over the pump making sure it is locked in position.You will need to use a breaker bar on the removal tool and turn the tool CLOCKWISE to release the pump (1/4 turn), or if you imagine the breaker bar being vertical, push towards the windscreen of your car,it takes quite a bit of force to unseat the pump hence the use of a breaker bar.

As for the waterpump itself, DO NOT buy anything other than AC DELCO as they are the highest quality and is a genuine GM replacement part.

Water pump part number AC Delco 252707

Installing the new pump does not require as much torque as removing the old one.
Tighten the new pump to 73 ft.lbs. making sure it is seated properly before tightening.

Don't forget to clean out the water pump housing prior to installing the new pump and don't forget to include a new water pump gasket and housing cover gasket.

It is also a good idea to install a new thermostat while you're at it.

Regards.

Caution:On models with a Delco Loc 2 or Theftlock audio system be sure the lockout feature is turned off before proceeding

• Disable the airbag system
• Remove the tilt lever if equipped
• Remove the upper and lower steering column covers

Ignition Switch

• Remove the ignition switch retaining screws
• Detach the ignition switch from the steering column housing assembly and unplug the electrical connectors

Key Lock Cylinder

• Turn the key to the run postion
• Depress the lock button and remove the key lock cylinder

partstore.com should have what you need

See if pulling up on the shifter lever makes it start.  You may have a bad switch.  Or try cleaning the battery terminals and retightening the battery terminals solves the problem.

checkout this site: www,delcolockcodes.com