- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
there is a clutch release issue here. clutch throw out arm adjustment, air in the system and if you have just replace the clutch, clutch plate in the wrong way round and the hub is hitting on the fly wheel bolts.
1994, most cars its in front of fuel tank
did you even look first? there?
some cars its on fire wall, (old cars)
following the fuel line, always works on all cars.
gas or diesel.
my comments are all gas (petrol)
now ill post the 1st line in the FSM (safety)_
If the fuel filter is being serviced with the rear of the vehicle higher than the front, or if the tank is pressurized, fuel leakage or siphoning from the tank fuel lines could occur. to prevent this condition, maintain the vehicle front end at or above the level of the rear of vehicle. also, relieve tank pressure by loosening the fuel fill cap. cap should be tightened after pressure is relieved.
is car stalled.> or is this a service , question, tune up.?
i logged in and bingo there it is by gas tank..
sure you didnt want to look and want us to .sure.
if i remember right if the battery light and check engine light is on, your alternators may be bad. your battery may just have enough to keep it running for a minute or so. you can take it out and get it tested at a auto parts store. or try charging your battery for awhile and see if it stays on longer. if this is completely wrong let me know
Driver side frame rail right where the door is. It's held in by a large hose clamp. It has 2 white plastic clips . 1 on each hose of the filter. When removing have a container that can hold gas ready because about a pint of gas will come out. Make sure new filter comes with new clips. I don't recommend using old ones. After new one in place turn key on and leave in run position for 20 seconds so filter can gill with fuel before starting and inspect fir leaks.
the nipple sticks out side the bell housing on the left side just above your hydralic line for your clutch,auto zones web has a complete diagraham and steps for bleeding
×