1995 Ford F350 Logo
A
Anonymous Posted on Jul 01, 2014
Answered

Obd1 trouble codes

WHAT ARE MANUFACTURER SPECIFIC CODES #4095 #007

Answer This Question

1 Answer

Micheal Schoen

Micheal Schoen

Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

  • Contributor 1 Answer
  • Posted on Jul 02, 2014
Micheal Schoen
Contributor
Level 1:

An expert who has achieved level 1.
New Friend:

An expert that has 1 follower.

Joined: Jul 02, 2014
Answers
1
Questions
0
Helped
114
Points
1

Anytime that you get a code that isn't listed, it is usually a fault in the PCM.

3 Related Answers

Anonymous

  • 667 Answers
  • Posted on Jun 02, 2009

SOURCE: ODB-II Trouble Code of 1151

P1151-Lack of HO2S-21 Switch, Sensor Indicates Lean
A Heated Exhaust Oxygen (HO2S) sensor indicating lean at the end of a test is trying to correct for an over-rich condition. The test fails when the fuel control system no longer detects switching for a calibrated amount of time.

A code P1151 may mean that one or more of the following has happened:
Electrical:

  • Short to VPWR in the harness or HO2S
  • Water in the harness connector
  • Open/shorted HO2S circuit
  • Corrosion or poor mating terminals and wiring
  • Damaged HO2S
  • Damaged PCM
Fuel System:
  • Excessive fuel pressure
    Leaking/contaminated fuel injectors
    Leaking fuel pressure regulator
    Low fuel pressure or running out of fuel
    Vapor recovery system
Induction System:
  • Air leaks after the MAF
  • Vacuum Leaks
PCV system:
  • Improperly seated engine oil dipstick
EGR System:
  • Leaking gasket
  • Stuck EGR valve
  • Leaking diaphragm or EVR
Base Engine:
  • Oil overfill
  • Cam Timing
  • Cylinder compression
  • Exhaust leaks before or near the HO2S(s)
Do you have any running or driveability problem, with this code usually you will not, check these things and makes repairs as necessary, not all of these will be wrong but at least one may be wrong, let me know what you find, hope this helps

Ad

Anonymous

  • 8197 Answers
  • Posted on May 22, 2011

SOURCE: need to no diagnostic trouble

That code means that your DSI has goone bad and needs to de replaced. Please look at the link below.

http://forums.focaljet.com/svt-headquarters/527188-dsi-imrc-issue-code-p1518.html

skychief2001

Stephen

  • 21873 Answers
  • Posted on Oct 12, 2012

SOURCE: i got a code p1747 electronic pressure control solonoid short circuit where is this located and will that cause my truck to throw all the shift solonoid codes

The solenoids are inside the transmission, if you are getting more than one code you may have a problem with the wiring harness going into the trans.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
2answers

Codes for 1991 c 1500 5.7

1988-98 Chevy and GMC C/K 1500/2500/3500 Pickup Trucks ...

 https://haynes.com > en-us > tips-tutorials > 1988-98-ch...
OBD-I trouble code chart ; 32, Exhaust Gas Recirculation (EGR) failure, Check the vacuum source and all vacuum lines. Check the system electrical connectors at ...

OBD1 Codes - Trouble Code List & Reading (GM) - Mechanic ...

 https://mechanicbase.com > OBD Codes
Jan 15, 2022 - In this guide, we will go through everything you have to know about OBD1 Trouble Codes. Learn to read the trouble codes without a scanner ...
 ‎OBD1 Trouble Code List · ‎OBD1 Connector Wirings Pinout


GM OBD/OBD2 Codes - TroubleCodes.net

https://www.troublecodes.net > gm
GM Specific Codes ; 64. MAP sensor voltage low; RH side O2 sensor lean ; 65, RH side O2 sensor rich ; 66. 3-2 Control solenoid circuit fault(4L60-E); A/C pressure ...

GM OBD I Trouble Code Chart - RepairPal

 https://repairpal.com > gm-obd-i-code-chart
Jul 5, 2018 - GM OBD I Trouble Code Chart ; Code 15, Engine coolant temp sensor error (low temp indicated) ; Code 16, System voltage too low ; Code 17, Camshaft position sensor ...
 ‎Code 12 · ‎Code 32 · ‎Code 42
GM OBD Trouble Code 12
Sept 5, 2012
GM OBD Trouble Code 32
Sept 5, 2012
GM OBD Trouble Code 33
Sept 5, 2012
GM OBD Trouble Code 22
Sept 17, 2012
More results from repairpal.com
Read full answer
Mar 28, 2022 • 1991 Chevrolet C1500
1helpful
1answer

Trying to find a OBD l scanner for a 95 dodge Dakota for under a $100.00, or can I use a OBD ll scanner with an OBD l adapter and achieve the ability to read and clear codes?
An OBD2 scanner can sometimes read an odd OBD1 code but there is no consistency. The OBD2 system is designed to be universal but only as far as faults that can affect exhaust emissions - other faults on the OBD2 system and the OBD1 system are manufacturer/model specific and require either dedicated diagnostic equipment or some very comprehensive software.
Read full answer
Jun 30, 2019 • 1995 Dodge Dakota
0helpful
2answers

How do I access the trouble codes on a 1995 Mercury Grand Marquis without a scan tool?
You can access them by going to the link, some late 1995 vehicles were OBD2, then you would have a diagnostic connector under the dash below the steering wheel, otherwise you do it under the hood (OBD1). FORD 1983 1995 OBD1 Decoder
Read full answer
Oct 07, 2016 • 1995 Mercury Grand Marquis
0helpful
1answer

I have 2005 envoy 4.2L engine light with arrow pointing down and loses power all gauges are fine what is the problem
How long since a tune-up? Can you check for applicable trouble codes? To check codes yourself, at the least, you need an obd2 code reader, that will check manufacturer specific codes as well as po codes.

Some of the national brand auto store will check codes for free. I don't know if they will check manufacturer specific codes? To quote some of my colleagues, if the info is free, it isn't worth much. Use your best judgement.
Read full answer
Jun 06, 2016 • Cars & Trucks
1helpful
2answers

Where can I get list of trouble codes OBD?

[PDF]ON-Board Diagnostic Trouble Codes

https://www.dmv.de.gov/services/Vehicle_Services/dtc_list.pdf
The list below contains standard diagnostic trouble codes (DTC's) that are used by ... all OBDII systems) or is specific to the vehicle manufacturer. The remaining ...
Read full answer
Nov 07, 2015 • Cars & Trucks
0helpful
1answer

Is there a knock senser on a 1994 Mazda b3000. The code flashes 331
The engine in your B3000 may not be the original; I find no listing for that code, only these:

Mazda Trouble Codes and Retrieval Method OBD1

Look down the page for the only codes I found listed and they are all OBD1 prior to 1995.
Read full answer
Jun 04, 2015 • Mazda Cars & Trucks
0helpful
1answer

Engine code list
2 digit numbers .... your vehicle is before 1996?

google OBD1 trouble codes for the manufacturer

example, OBD1 trouble codes for Ford

but you didn't say what the year make model is so this is where my answer stops

-------

edit saw it is for a dodge

redo that key on-off-on-off-on sequence and re-count the engine light flashes... something's not correct with the code numbers

http://dodgeforum.com/forum/1st-gen-dakota/182034-obd-1-codes.html
Read full answer
Apr 20, 2015 • Cars & Trucks
0helpful
2answers

Whats the symptoms of a bad cam sensor
The most obvious symptom would be a check engine light; however, since you have a vehicle with a manufacturer date before 1996, you don't have the more integrated and informative OBD2 plug. If you have a OBD1 code reader specific to Chrysler, then you may still be able to pull the trouble code.

Many vehicles will not even start if the camshaft sensor is reading incorrectly, as the vehicle would be unable to properly calibrate its engine timing.
Read full answer
Oct 26, 2012 • 1995 Jeep Wrangler
3helpful
1answer

I have a 1998 Nissan Maxima GLE, I Failed the Emission Inspection (DTC) Diagnostic Trouble Codes of "P1492","P1105" What these Codes exactly? mean
A code P0300 may mean that one or more of the following has happened:
  • Faulty spark plugs or wires
  • Faulty coil (pack)
  • Faulty oxygen sensor(s)
  • Faulty fuel injector(s)
  • Burned exhaust valve
  • Faulty catalytic converter(s)
  • Stuck/blocked EGR valve / passages
  • Faulty camshaft position sensor
  • Defective compute
  • P1105MAP/BARO Pressure Switch Solenoid Valve
  • Check and clean the MAP sensor, or replace.
  • P1492EVAP Canister Purge Control/Solenoid Valve (Circuit)
  • Replacing the purge solenoid will clear code P1492 This should also clear code P0300 as well.
Read full answer
Oct 16, 2012 • 1998 Nissan Maxima
0helpful
1answer

Obd1 codes
http://www.2carpros.com/articles/retrieve-trouble-codes-for-chrysler-dodge-plymouth-odb1-1995-and-earlier-car-mini-van-and-light-trucks

These are the two digit codes.
Read full answer
Aug 27, 2012 • 1994 Plymouth Sundance
Not finding what you are looking for?

View Most Popular

1995 F350

  • Cars & Trucks

Related Question

Codes for 1991 c 1500 5.7

  • 1991 Chevrolet C1500

Related Topics

124 views

Ask a Question

Usually answered in minutes!

Popular Questions

What is a tbc fault on a 2006 ford f350 6.0

2006 Ford F 350 Super Duty

I HAVE A FORD F350 V10 [GAS] THAT WILL SHUT DOWN

1999 Ford F350 Regular Cab

2004 f350 power steering problem.

Ford F-350 Cars & Trucks

Looking for a wiring diagram

1994 Ford F350 Crew Cab

I have a 95 Ford F350 with the 460 motor. It started running fine when cold but after it warms up it starts to run rough, lose power, and runs REAL rich. I'm only getting a little more than 2mpg.

1995 Ford F350

Check Out the Latest Top Trucks Report!
Check Out the Latest Top Trucks Report!

View all Fixya Reports

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...