How to check to see what is wrong with the horn . it does not work. the fuses are all good
SOURCE: 1999 town & country cruise control stopped working
2001 town & country. My airbag/seat belt light came on, cruise control and horn stopped working. Dealer said it was the "clock spring" and usually covered as a recall item.
SOURCE: chrysler town and country wiring diagram
2002 Chrysler Town and Country Car Stereo
Car Radio Battery Constant 12v+ Wire: Gray/Red
Car Radio Accessory Switched 12v+ Wire: Black/Pink
Car Radio Ground Wire: Strap or Chassis
Car Radio Illumination Wire: Orange/Tan
Car Stereo Dimmer Wire: N/A
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: Gray/Green
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Green
Left Front Speaker Negative Wire (-): Green/Brown
Right Front Speaker Positive Wire (+): Gray
Right Front Speaker Negative Wire (-): Gray/Brown
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Green/Black
Left Rear Speaker Negative Wire (-): Green/Orange
Right Rear Speaker Positive Wire (+): Gray/Black
Right Rear Speaker Negative Wire (-): Gray/Pink
SOURCE: Map light replacement on 2006 Town and Country?
Jun 17, 2009- ok I just looked at it. it is simple.
the lens pivots and presses a switch in on one end to make the light come on. take a butter knife or very small screw driver and reach in between the lens and the black center console. there you will CAREFULLY press a flat tab to the side that is made onto the lens ( I hope you dont break this tab).
on the very opposite position on the clear lens towards the door is where the lens has a tab that has a small hole in it. there is a plastic pin made onto the console trim that fits into this hole so the lens will pivot. this will give you an idea of which direction to pull the lens when you press in the tab,. it does look like it would break easily. I havent had to take mine off yet thankfully.
please visit again and rank this answer if this helps!... good luck
SOURCE: 2006 town and country check engine light is on.
According to my OBD2 reader manual a P0406 code means the Exhaust Recirculation Gas sensor is in fault. So it means that you have a problem with your EGR valve and/or sensor. So just change them, but be warned, even jobber model go for over 100$ normally, so might be an idea to scrounge around the scrap yards.
SOURCE: On my 1997 Chrysler Town & Country , my Horn
This is definitely an issue with your clockspring. The clockspring is a device in the steering column that provides electrical contacts for horn, cruise and airbag. The good news for you is this part is covered under a Chrysler warrantee / recall.
135 views
Usually answered in minutes!
×