SOURCE: 2002 Izusu Rodeo timing problems
Check with your local Izuzu dealer, there is a procedure to set the cams in proper relationship with each other. This involves turning the cams up to 8 rotations to have them "jump" into the proper spot. I have had the same problem and found a bulletin that shows the correct way to time the engine.
SOURCE: NO POWER WHEN DRIVING
Fixed problem it was the ignition coil, now it runs very smoothly! thanks to all that helped
Jon.
SOURCE: trouble getting marks aligned on 2001 Izusu Rodeo
if its a 6VE1 engine you might want to remove rocker covers and put front lobes of camshafts in position shown in picture with cam gear timmed up at same point cam gear are 3:1 ratio
look closely at cam gears in pic to see front lobe positions for both banks
SOURCE: Replaced the MAP sensor, MAF sensor, fuel filter,
Let the vehicle warm up for 10 minutes at idle and shift it to Reverse if the RPM bumps up thats fine but if it dosent then replace the IAC idler air control valve.
61 views
Usually answered in minutes!
×