How do i take off the center console on a 1997 ols. cutless sprime

'97 Cutlass Supreme SL 3.1 AC charging port is under the back side of the air cleaner housing on the drivers side and the lowest port is the fill port.

All of the warning lights are on the same circuit for power. The low fuel light gets a ground from the logic board inside the instrument cluster and from the gas tank sending unit.

Malibu/Cutlass 1997-2000 Center Console

• REMOVAL & INSTALLATION

Print

REMOVAL & INSTALLATION

1. Remove the shift control handle by unfastening the retaining clip and lifting the handle off.
2. Gently pry upward on the trim plate in order to disengage the retainers from the console.

NOTE It may be necessary to move both seats several times to properly remove the center console.

1. Remove the rear cupholder.
2. Unfasten the 6 retaining screws, then remove the console.

Fig. Location of the center console's attaching hardware. Note that both seats may have to be moved a few times in order to access all of the console retainers

This engine uses a computer controlled ignition system, in the engine the computer controlls the timing as it is needed, there are no adjustments on the timing that you are able to do, so there are nomark. hope this helps good day

fuse 39 in fuse block

what i usually do is look into the hole on the clutch and line it up with the spigot bearing hole and then tighten it up

You can try to use the spray contact adhesive

If you have the 3100 engine your oxygen sensor is located in the exchaust manifold towards the firewall.

The thermostat is on the intake by the exhaust cross over. The crossover will have to be removed to get the thermostat housing out. If the intake gaskets are leaking fix them and change the thermostat while the intake is off. The only reason I say this is because the intake gaskets are a common problem.

have you bled the system