How to replace turn signal bulb in 2012 chrysler 200

Without naming the make and model of the car, it is very difficult to answer your question. That explains why so many questions go un-answered on FIXYA.

Kevin, could not find your year, to change your 2012 steps will be similar. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

How To Install Replace Turn Signal Switch Dodge Caravan 01 07 Chrysler...
Turn Signal Switch Replacement Service Cost YourMechanic

There are lots of issues with the multifunction switch for Chrysler

Is your parking brake on.
to turn off your daytime running lights on your island you put your mergency break on check to see if your emergency brake switch is bad or your emergency brake is on.

Open the hood and reach behind the headlight cluster. Turn the signal holder counter clockwise to remove it.
Pull the bulb out (think they are the wedge type), and replace new one (using paper towel to avoid getting any any grease/oil from your hand on it), you should hera it click in.
Now put the signal holder back in turning it clockwise.
If doing the other side, the fliter housing has to removed in order to get to the bulbs.

Did you just recently purchase this vehicle? When you first turn the key on (don't start the engine) it does a bulb check. Look to see if the 'Air Bag' light comes on. If not, then you need to replace that bulb. It beeps to let you know the bulb isn't working.

Turn signal tail lights and BRAKE LIGHTS NOT WORKING

It can be faulty brake light switch causing the problem or its blown brake light bulb. First check and confirm brake light lamp is working and that's not the case.

For turn signal not working it can be faulty turn signal switch or its issue with wiring:----

==========

To trouble shoot brake and turn signal related problem, check the help links mentioned below:-----

Click the link:----
1996 Buick Regal Grand Sport Brake light Switch Location? http://schematicsdiagram.blogspot.in/2012/04/1996-buick-regal-gran-sport-brake-light.html

-----------
No brake lights on Buick? http://schematicsdiagram.blogspot.in/2012/04/no-brake-lights-on-buick.html

----------
Brake lights not working on 1989 BUICK REGAL?

http://schematicsdiagram.blogspot.in/2012/04/brake-lights-not-working-on-1989-buick.html

-------
How to replace Brake light switch on Chevrolet Tahoe?

http://technoanswers.blogspot.in/2012/02/how-to-replace-brake-light-switch-on.html

---------------
How to replace Parking, turn, and Brake Lights on car?

http://schematicsdiagram.blogspot.com/2011/06/how-to-replace-parking-turn-and-brake.html

----------
Upper brake lights work, but low brake light not working?

http://schematicsdiagram.blogspot.com/2011/12/upper-brake-lights-workbut-low.html

------------
1997 Cadillac Catera: How to replace Brake Light Switch?

http://howtobyme.blogspot.in/2012/06/1997-cadillac-catera-how-to-replace.html

------------

2003 Chevrolet S10 Tail light Fuse http://schematicsdiagram.blogspot.com/2012/11/2003-chevrolet-s10-tail-light-fuse.html

---------
Chevrolet Parking light and Tail lamp light Wiring diagram http://schematicsdiagram.blogspot.com/2012/11/chevrolet-parking-light-and-tail-lamp.html

----------
Car Tail Lights Not Working?

http://schematicsdiagram.blogspot.com/2011/12/car-tail-lights-not-working.html

----------
Turn Signal Not working http://technoanswers.blogspot.com/2012/11/turn-signal-not-working.html

----------
Right turn signal not working on Pontiac Car?

http://schematicsdiagram.blogspot.com/2011/12/right-turn-signal-not-working-on.html

--------
Only one side indicator light working on car?

http://schematicsdiagram.blogspot.com/2011/12/only-one-side-indicator-light-working.html

-----------
Turn signals not working on 1987 Jeep Wagoneer? http://schematicsdiagram.blogspot.com/2011/12/turn-signals-not-working-on-1987-jeep.html

1996 Chrysler LHS brake light circuit wiring diagram?

http://technoanswers.blogspot.in/2012/02/1996-chrysler-lhs-brake-light-circuit.html

----------
How to replace rear Brake lights on 2004 Toyota RAV4? http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-rear-brake-lights-on.html

------------
One brake light on driver side not working, but other lights work?

http://schematicsdiagram.blogspot.com/2011/12/one-brake-light-on-driver-side-not.html

----------
2002 Lincoln Town car Fuse Box http://schematicsdiagram.blogspot.com/2012/11/2002-lincoln-town-car-fuse-box.html 2007 KIA Rio: Brake Light Fuse Box Diagram?

http://repairhelpcenter.blogspot.in/2012/06/2007-kia-rio-brake-light-fuse-box.html

-------------
Overhead Brake lights not working on 1999 GMC Sierra 4x4?

http://technoanswers.blogspot.in/2012/03/overhead-brake-lights-not-working-on.html

---------
2004 Ford Mustang: Brake light Fuse Location?

http://howtobyme.blogspot.in/2012/05/2004-ford-mustang-brake-light-fuse.html

---------

These will help.

Thanks.

1) Reset the ignition timing according with the specification manufacturer.
2) Test the primary circuit and secondary circuit from ignition system and replace, see the diagrams, God bless you.

To replace turn signal bulb,click the link below :---http://howtobyme.blogspot.in/2012/02/how-to-replace-front-lower-turn-signal.html
---------This procedure will help.Thanks.

Take the turn signal bulbs off and check for corrosion. Clean the bulb contacts and harnesses. Put enough bulb grease on the contacts but not on the bulbs and try them out. You can clean them with a wire brush or how ever you find suitable.