My tranny is slipping I DON'T ALWAYS HAVE 1ST GEAR & won't go into 4th gear all the time. Does one solenoid shift 1st & 4th & the other one does 2nd & 3rd? Or is it 1st & 2nd & the other 3rd & 4th?
SOURCE: 4l60e slips in 3rd and 4th
There are to many things that can cause this problem, best thing to is go get the ECM scanned for DTC codes at a transmission shop or Auto zone or Parts Source since they scan for free.
The ECM should have DTC code in it's memory on how the transmission is Performing and have the Transmission line tested for Fluid pressure.
Good luck and hope this helps. Oh and also ways check with more then on transmission shop if there tell you that you need a new Transmission,
It could be a simple as the transmission filter falling off causing the lost of transmission fluid pressure. Check the transmission fluid too.
SOURCE: my 88 chevy with 700r4 wont upshift from 3rd to 4th
you have a valve body problem, some of the speed sonsor controls are malfunctioning... need to get into the valve body... check fluid condition for dirty and burned condition...
SOURCE: 1st and 2nd gear won't catch in my manual 96
it is very likely this is being cuased by worn shift linkage and not the transmission itself, check the shift rods and bushings for being excessively loose, also any trans repair shop will do a test drive and give you a free diagnosis in hope of getting the work, things are tight right now. please rate this.
SOURCE: 4l60e going from 1st to 3rd and dont have overdrive any more
You most likely have a broken sunshell inside the transmission. They tend to go out when the transmission is shifted to drive when while still rolling in reverse.
SOURCE: 96 chevy blazer 3rd gear and overdrive slipping
i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do
479 views
Usually answered in minutes!
×