What kind of oil is the best for my 2000 jeep grand cherokee

SOURCE: How to replace headlights on 2000 Jeep Grand Cherokee

One long bolt at the top - requires a 7mm socket to remove the bolt. The light housing will pry out with a screw driver. There are three ball and socket type connectors that hold the housing in and I just pryed off the plastic housing carefully and "balls" pop out of the sockets. Finally, I was replacing the faded plastic housing and it came with a new wiring harness. It's impossible to reach the connector to use the new wiring harness that comes with the new plastic light housing. So just use the existing wiring harness with the new light assembly.

SOURCE: 2000 jeep grand cherokee 4.0 liter engine timing belt replacement

If you have the same pulley arrangement that most 4.0 engines have that pulley is an idler not a tensioner. Your power steering pump has a pivot bolt, and a slide under the pump. You adjust belt tension using the pump.

Marvin

• 85242 Answers
• Posted on Apr 07, 2009

SOURCE: Best brand of antifreeze in 2000 Jeep Cherokee

the best coolant is by far is the MOPAR/JEEP OEM coolant, next to that I would use Prestone brand long life coolant type..

Greg Bernett

• 2993 Answers
• Posted on Jan 12, 2010

SOURCE: Where is the oil pressure sending unit located on

Removal & Installation

1. Disconnect the negative cable from the battery.
   
2. Raise vehicle on hoist.
   
3. Remove front splash shield.
   
4. Disconnect oil pressure sender connector (4).
   
5. Remove the pressure sender (2).
   

1. Install oil pressure sender.
   
2. Connect oil pressure sender wire.
   
3. Install front splash shield.
   
4. Lower vehicle.
   
5. Connect the negative battery cable.
   

SOURCE: how to change oil pressure sending unit on jeep

First things first do you have a repair manual? If you don't have one get one, Changing the unit is realitively simple, you just disconnect the battery, disconnect the oil pressure sending unit's electrical connector, remove the sending unit, now most sending units are small and look like a short chubby spark plug with an electrical blade connector on the end of it. simply use a wrench to loosin and remove and install by screwing in and tightening and reconnecting the electrical connecter then the battery and your as good as new!