SOURCE: replace rear brake light
Open up the hatch and look for the screws that hold the tail light assembly to the body. After removing them you can gently pull the whole tail light from the truck. You will seee the sockets that the bulbs are in and they twist like a bottle cap to get to the bulb. Just pull the bulb from the socket and reverse what you did to put it back together.
SOURCE: how to change rear disk brakes on a 2004 jeep grand
Try the autozone.com website and register the vehicle there. It doesn't cost anything and will give you access to an online repair manual for the vehicle. The steps and procedures for replacing the brakes should be available there. Hope this helped and best wishes.
SOURCE: 2004 grand cherokee jeep power windows and
Check for a 40 amp blown fuse for the BCM this controls those 2 unit. If this checks ok disconnect the BCM module and plug back in this will reset it the BCM is located under the Drivers side kick panel against the firewall. If it work after the BCM reset replace the BCM it will work only temporaraly.
SOURCE: turn signals on my 2004 jeep don't work what to
If one of your bulbs has blown you will get a faster relay click when you activate the indicators. It sounds as though the relay itself could be sticking / broken.
Of course it could just be a blown fuse, I would check that first before changing relays
SOURCE: 2004 Jeep Grand Cherokee blend door replacement
its not the door its self that doesn't work,it is opened by a vacume valve and closed with a vacume valve,and it is not an easy job even for a mechanic
94 views
Usually answered in minutes!
×