Cars & Trucks Logo

Related Topics:

A
Anonymous Posted on Jun 23, 2014

Cvt train fluid drain and refill 2007 Toyota Blade 2.4 engine

How to service the cvt trains on toyota blade has a 2.4 motor

5 Related Answers

Anonymous

  • 90 Answers
  • Posted on Jan 25, 2009

SOURCE: How do I change a rear wiper blade on a 2004 Toyota Sienna

You gotta flip the wiper arm up, and turn the blade out. Underneath you will find a tab in the center. Press in on this tab and slide the blade out.

Ad

Anonymous

  • 27 Answers
  • Posted on May 30, 2009

SOURCE: 2007 Toyota 4 runner transmission filter and fluid change??

at 50,000 miles there is really no need. i would wait and save up that money and do a transmission flush 7- 10 quarts of toyota f-type fluid can be costly but a flush removes all of the fluid and garnish along with any fine shavings (normal wear and tear) out of the tranny and replaces it with new clean fluid. normal intervals would be at about 80-100,000 miles. you should be able to find preventative maintenance schedules in your owners manual. if not any repair facility would have it on their computer.

aaron johnson

  • 204 Answers
  • Posted on Jun 17, 2009

SOURCE: Where is the 2007 toyota tundra transmission dipstick

if its a manual transmission you will have a plug on the side of the trany you take the top plug out to check the fluid

mecanica03

ROBERT GARCIA

  • 926 Answers
  • Posted on Jul 05, 2009

SOURCE: My 2007 Toyota Tundra 4.7l shows VSC OFF lights

check air filter for dirty , how many miles or kms have your car? , maybe need to replace spark plugs, try to reset the ecu for a momentany malfunction, remove the negative battery terminal few minutes and reconnect,start engine and drive, check if lights goes off , please write me

Anonymous

  • 1 Answer
  • Posted on Sep 05, 2009

SOURCE: Replacing rear wiper blade

I purchased a Trico "Exact Fit" #12-A rear wiper blade at Advance Auto Parts for my 2006 RAV4. The directions are very clear. It took about 3 minutes. The key is to open the plastic cover at the bottom joint of the blade by spreading the both sides with your index fingers and pulling straight out. This opens the cover and allows you to bring the blade to a 90 degree angle.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have problem with wiper blade change in front of Toyota Previa 1997, 2.4i. Can't find any common, originals only from Toyota customer service offered me 58EUR per 1 unit. How to solve the problem?

I don't understand the problem. There are lots of pattern and universal blade applications on ebay for the Previa.

I suggest you call at your local motor factor and ask. Halfords have a fitting service. If you can't drive away with nice new blades you won't have to pay, similarly for any good independent repairer.
0helpful
1answer

Engine light is on then a wrench light comes on for awhile. When this happens the car slows down to a crawl.2012 ford tauras

The wrench symbol light is a warning light for the electronic throttle control system . Drive by wire ! The system uses electrical inputs from gas pedal sensors to the engine computer ,then by the voltage signal inputs the PCM - engine computer controls a electric motor to open throttle blade . This allows more air to enter the engine , the PCM can see that increase in air volume by the inputs from the mass air flow sensor . The PCM will add more fuel so you can go faster . Cool ! When the light comes on and the vehicle slows down , it's gone into limp mode . The PCM saw a voltage input it didn't like . There are two position senors in the gas pedal assembly and there are two throttle position sensors in the throttle body on the engine . Drive by Wire training Check out a few of these training videos ! GM ,Ford , Toyota , doesn't matter all work the same .
0helpful
1answer

My 2007 voxy isn't picking quickly it can't accelerate beyond 60km per hour once forced to it stops the engine i changed the gear oil atf with Toyota 4 instead of cvt could it be the cause

Not really. But if you haven't put many miles on it. Replace the ATF fluid with CVT fluid. This will kill the transmission. If it hasn't already done damage. Have the codes read, even if the light is not on.
0helpful
1answer

Toyota Fielder

Toyota Fielder is equipped with (Continuous Velocity Transmission) CVT. Better to replace the CVT oil every 100,000 Km. The recommended oil is Toyota Genuine CVT Fluid TC with part number 08886-02105 4 Litres. Requires inspection after every subsequent 40,000 Km under normal conditions and 25000 Km under severe conditions.
0helpful
1answer

When to change Toyota Fielder CVT oil

The CVT fluid should be changed at 140 000km by a qualified technician with genuine Toyota CVT Fluid TC
0helpful
1answer

Good day.how many liters will i consume if I'll going to change the automatic transmission fluid of my toyota 2c engine.

V6 or 4 cylinder engine?

A trans drain and refill is about the same as an engine oil change.

Find the trans. Under the trans is an oil pan, much like the one on the engine. There should be a drain plug on the bottom of the trans pan.

Depending on the model of trans it can hold say 6-8 quarts of fluid. Only about 2.6 will drain out the pan as the rest is held in the torque converter.

The easiest approach is to measure how much fluid drained out and refill with the same amount.

The trains has a dipstick. Check fluid when hot, engine running after moving the shifter from Park to Low and return. The dipstick will have a "Hot" and "Cold" mark, use the hot mark if the fluid is hot. The stick will also have the type of fluid used, typically Dexron III or now called "ATF" fluid. Read the container to make sure it is a substitute for Dexron III.

As only 1/3 to 1/2 of the total fluid amount drains out of the pan at one time you will need to do a few drain and fills over time to get most of the old fluid out.
1helpful
1answer

HOW TO CHANGE WIPER BLADES ON A 2004 TOYOTA HIGHLANDER

Hi,
Here is a website for installing refill blades. It requires you to select your blade type from the pictures. Onse selected, there is a nice instruction to install your refill:

http://www.brandsport.com/towiwiblandi.html

I hope this helps... Good luck!
8helpful
3answers

Replacing rear wiper blade

I purchased a Trico "Exact Fit" #12-A rear wiper blade at Advance Auto Parts for my 2006 RAV4. The directions are very clear. It took about 3 minutes. The key is to open the plastic cover at the bottom joint of the blade by spreading the both sides with your index fingers and pulling straight out. This opens the cover and allows you to bring the blade to a 90 degree angle.
Not finding what you are looking for?

1,554 views

Ask a Question

Usually answered in minutes!

Top Toyota Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

926 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...